Difficulty

Difficult

Steps

11

Time Required

                          25 minutes

Sections

3

  • Back Panel
  • 4 steps
  • Battery
  • 2 steps
  • Screen
  • 5 steps

Flags

1

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

  • BackHP Pavilion 15-eg0025nr

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

The screen is also known as the display panel, and is the part of the laptop that emits light and shows you pictures and websites. The screen is held together by the display bezel, the frame surrounding the screen.

You may need to replace your screen if it is cracked or if there are large, black spots on your screen. Try our troubleshooting page for the HP Pavilion 15-eg0025nr to find out if your screen needs to be replaced.

Removing the screen is difficult. Be careful to not bend or snap the screen as you remove it, and always make sure the laptop is unplugged and powered off before repairing.

What you need

Step 1

              Back Panel
  • Unplug and turn off the laptop before removing the back panel
  • Flip over the computer so that the back panel is facing upwards.
  • Remove the two silver screws on the bottom of the laptop using a Phillips #00 screwdriver.

Unplug and turn off the laptop before removing the back panel

Flip over the computer so that the back panel is facing upwards.

Remove the two silver screws on the bottom of the laptop using a Phillips #00 screwdriver.

1024

Step 2

  • Peel up each end of the two gray rubber stoppers using your fingers or an opening pick.
  • This may be difficult if it is your first time removing them.
  • Remove the two black screws underneath the rubber stoppers with the Phillips #00 screwdriver

Peel up each end of the two gray rubber stoppers using your fingers or an opening pick.

This may be difficult if it is your first time removing them.

Remove the two black screws underneath the rubber stoppers with the Phillips #00 screwdriver

Step 3

  • Slide the opening pick around the edges of the laptop where the chassis has a seam.
  • You will hear a clicking noise as you undo the clips of the chassis.
  • It may be easier to start with the four corners of the laptop, and then follow through with the sides.

Slide the opening pick around the edges of the laptop where the chassis has a seam.

You will hear a clicking noise as you undo the clips of the chassis.

It may be easier to start with the four corners of the laptop, and then follow through with the sides.

Step 4

  • Remove the back panel completely.
  • With the back panel removed, you can now access parts of the laptop such as the fan or the battery.

Remove the back panel completely.

With the back panel removed, you can now access parts of the laptop such as the fan or the battery.

Step 5

              Battery
  • Remove the five screws from the battery using a Phillips #00 screwdriver.

Remove the five screws from the battery using a Phillips #00 screwdriver.

Step 6

  • Remove the battery from the laptop.

Remove the battery from the laptop.

Step 7

              Screen
  • Do not attempt to remove the screen without first removing the back panel and battery. Ensure that the laptop is powered off before removing the screen
  • Find the hinge bezel where the display bezel meets the back panel.
  • Using an opening pick, unclip the hinge bezel by sliding the pick along the hinge.

Do not attempt to remove the screen without first removing the back panel and battery. Ensure that the laptop is powered off before removing the screen

Find the hinge bezel where the display bezel meets the back panel.

Using an opening pick, unclip the hinge bezel by sliding the pick along the hinge.

Step 8

  • Using an opening pick, pry open the top, sides, and bottom of the display bezel.
  • Remove the display bezel and set aside.

Using an opening pick, pry open the top, sides, and bottom of the display bezel.

Remove the display bezel and set aside.

Step 9

  • Remove the six golden screws with a Phillips #00 screwdriver and set aside.
  • There are three screws on each side.

Remove the six golden screws with a Phillips #00 screwdriver and set aside.

There are three screws on each side.

Step 10

  • Remove the two silver screws at the top of the display panel with a Phillips #00 screwdriver.

Remove the two silver screws at the top of the display panel with a Phillips #00 screwdriver.

Step 11

  • Using an opening pick, carefully pry the screen from top, sides, and bottom of the display panel.
  • Be cautious to not bend or snap the screen as you pry it out.
  • Remove the screen and set aside.

Using an opening pick, carefully pry the screen from top, sides, and bottom of the display panel.

Be cautious to not bend or snap the screen as you pry it out.

Remove the screen and set aside.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Elaina Bonner

Member since: 09/06/2022

298 Reputation

                                      1 Guide authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       University of Colorado Denver, Team 1-1, Campeau Fall 2022                        

                                                  Member of University of Colorado Denver, Team 1-1, Campeau Fall 2022 



                    UCDENVER-CAMPEAU-F22S1G1                     


                                            4 Members                     


                                            3 Guides authored