Hp Pavilion 15 Ba003Ds Screen Replacement Repair Guide

Difficulty

Very difficult

Steps

7

Time Required

                          35 minutes - 1 hour            

Sections

1

• Screen
• 7 steps

Flags

0

• BackHP Pavilion 15-ba003ds

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

The screen itself is a thin display module that is fastened behind the frame of the upper portion of your laptop. Aside from obvious cracks, symptoms of a bad or damaged screen include the appearance of “dead” pixels, blotches, or a screen that is having trouble reaching its full brightness.

Before using this guide, check the settings on your device for brightness and contrast to see if the image cannot be corrected.

This instruction requires a steady hand and attention to technique. A mistake in this process could result in damage to the screen or wires within your HP Pavilion.

Check to make sure that you have all of the required tools and parts before beginning this guide.

Before you get started, power off the device completely and disconnect the device from any external power source.

What you need

Step 1

              Screen               

• Apply firm pressure and slide the metal spudger along the outside edges of the front panel screen.
• When using the metal spudger, be careful not to press into the plastic panel too hard. It may damage internal cables or the panel.

Apply firm pressure and slide the metal spudger along the outside edges of the front panel screen.

When using the metal spudger, be careful not to press into the plastic panel too hard. It may damage internal cables or the panel.

1024

Step 2

• Continue sliding the metal spudger to the bottom of the screen.
• Don’t pull on the frame outwards as this will put pressure on the panel and damage it.

Continue sliding the metal spudger to the bottom of the screen.

Don’t pull on the frame outwards as this will put pressure on the panel and damage it.

Step 3

• Flip the laptop so the bottom is facing upwards.
• Using the metal spudger, separate the plastic panel off the screen.

Flip the laptop so the bottom is facing upwards.

Using the metal spudger, separate the plastic panel off the screen.

Step 4

• Once the panel is separated from the screen, gently pull it off and set it aside.
• Remove two 6mm Phillips #00 screws from the bottom of the screen.

Once the panel is separated from the screen, gently pull it off and set it aside.

Remove two 6mm Phillips #00 screws from the bottom of the screen.

Step 5

• Remove two 6mm Phillips #00 screws from the top of the screen.

Remove two 6mm Phillips #00 screws from the top of the screen.

Step 6

• Flip the screen down.
• Remove the tape from over the connector.
• Pull out the connector using your fingers.

Flip the screen down.

Remove the tape from over the connector.

Pull out the connector using your fingers.

Step 7

• Lift the screen away from the laptop.

Lift the screen away from the laptop.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Joseph Chia                     

Member since: 01/14/2020

334 Reputation

                                      3 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges                           

Team

                       York University, Team S1-G9, Woodhouse Winter 2020                        

                                                  Member of York University, Team S1-G9, Woodhouse Winter 2020 



                    YORK-WOODHOUSE-W20S1G9                     


                                            3 Members                     


                                            8 Guides authored