Difficulty

Moderate

Steps

12

Time Required

                          5 minutes

Sections

2

  • Battery and Back Cover
  • 8 steps
  • Wi-Fi Card
  • 4 steps

Flags

0

  • BackHP Laptop 15-abxxx

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery and Back Cover
  • Flip the computer over so that the bottom cover is facing you.
  • Slide the two locks to the “unlock” position and remove the battery.

Flip the computer over so that the bottom cover is facing you.

Slide the two locks to the “unlock” position and remove the battery.

1024

Step 2

  • Remove the two 8mm screws underneath with a Phillips #1 screwdriver.
  • Use a plastic opening tool to remove the plastic feet.

Remove the two 8mm screws underneath with a Phillips #1 screwdriver.

Use a plastic opening tool to remove the plastic feet.

Step 3

  • Remove the two plastic tabs with a metal spudger.

Remove the two plastic tabs with a metal spudger.

Step 4

  • Remove the sixteen 8mm screws that hold the bottom cover with a Phillips #1 screwdriver.

Remove the sixteen 8mm screws that hold the bottom cover with a Phillips #1 screwdriver.

Step 5

  • Pull the Optical Drive out.

Pull the Optical Drive out.

Step 6

  • Remove the 3mm screws that were hidden under the Optical Drive with a Phillips #0 screwdriver.

Remove the 3mm screws that were hidden under the Optical Drive with a Phillips #0 screwdriver.

Step 7

  • Flip the computer back over.
  • Use a plastic opening tool to release the clips holding the keyboard section in place.

Flip the computer back over.

Use a plastic opening tool to release the clips holding the keyboard section in place.

Step 8

  • Close the lid and pull the screen and keyboard section up and away from the disconnected bottom cover.
  • The hard drive is NOT screwed into place on the underside of the keyboard section.

Close the lid and pull the screen and keyboard section up and away from the disconnected bottom cover.

The hard drive is NOT screwed into place on the underside of the keyboard section.

Step 9

              Wi-Fi Card
  • Locate the Wi-Fi card.

Locate the Wi-Fi card.

Step 10

  • Pull the cable from the clips and use the spudger to disconnect the wire from the Wi-Fi card.

Pull the cable from the clips and use the spudger to disconnect the wire from the Wi-Fi card.

Step 11

  • Use the Phillips #1 screwdriver to remove the single 4mm screw.

Use the Phillips #1 screwdriver to remove the single 4mm screw.

Step 12

  • Pull the Wi-Fi card up and out.

Pull the Wi-Fi card up and out.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Grace Chapek

Member since: 10/18/2017

101 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       UW Tacoma, Team S1-G2, Rose Fall 2017                        

                                                  Member of UW Tacoma, Team S1-G2, Rose Fall 2017 



                    UWT-ROSE-F17S1G2                     


                                            5 Members                     


                                            14 Guides authored