Difficulty

Moderate

Steps

5

Time Required

                          30 - 50 minutes

Sections

3

  • Back Cover
  • 1 step
  • Battery
  • 2 steps
  • Fan
  • 2 steps

Flags

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Markup Mishap

This guide needs better markups. Help out by correcting or making some markup annotations.

  • BackHP Omen 15-5002xx

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Before beginning, be sure to completely shut down the computer and it is unplugged from the charger.

What you need

Step 1

              Back Cover
  • Flip the laptop upside down so the backside is facing up.
  • Use a spudger or your fingers to remove the thin rubber strips that are attached from the edges of the laptop.
  • Remember where each thin rubber came from and set them off to the side.
  • Unscrew all 14 screw with the J00 JIS Screwdriver.

Flip the laptop upside down so the backside is facing up.

Use a spudger or your fingers to remove the thin rubber strips that are attached from the edges of the laptop.

Remember where each thin rubber came from and set them off to the side.

Unscrew all 14 screw with the J00 JIS Screwdriver.

1024

Step 2

              Battery
  • Open the case slowly from opposite sides of the laptop.
  • Use the J00 JIS screwdriver to remove eight screws securing the battery.

Open the case slowly from opposite sides of the laptop.

Use the J00 JIS screwdriver to remove eight screws securing the battery.

Step 3

  • Carefully remove the battery connector that is attached to the motherboard by slowly sliding it towards the battery with two fingers.
  • Remove the battery by lifting it up and out.

Carefully remove the battery connector that is attached to the motherboard by slowly sliding it towards the battery with two fingers.

Remove the battery by lifting it up and out.

Step 4

              Fan
  • Remove the twelve big screws with the J00 JIS screwdriver.
  • Remove all eight small screws with the 1.5 flathead screwdriver.

Remove the twelve big screws with the J00 JIS screwdriver.

Remove all eight small screws with the 1.5 flathead screwdriver.

Step 5

  • Carefully detach the fan connector that is attached to the motherboard by slowly sliding the connector out with two fingers.
  • Remove the battery carefully.

Carefully detach the fan connector that is attached to the motherboard by slowly sliding the connector out with two fingers.

Remove the battery carefully.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Eduardo Arellano

Member since: 09/01/2021

621 Reputation

                                      5 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       Gateway, Team 1-1, Saknee Fall 2021                        

                                                  Member of Gateway, Team 1-1, Saknee Fall 2021 



                    GCC-SAKNEE-F21S1G1                     


                                            5 Members                     


                                            6 Guides authored