Difficulty

Moderate

Steps

6

Time Required

                          10 minutes

Sections

2

  • HP Officejet Pro 6835 Cover Disassembly
  • 4 steps
  • Encoder Strip
  • 2 steps

Flags

0

  • BackHP Officejet Pro 6835

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              HP Officejet Pro 6835 Cover Disassembly
  • Open the main lid as far as it will go.
  • Use a plastic opening tool to gently pry off the hinge on the right side by pushing it to the left and off the hook.
  • Open the lid further.

Open the main lid as far as it will go.

Use a plastic opening tool to gently pry off the hinge on the right side by pushing it to the left and off the hook.

Open the lid further.

1024

Step 2

  • Use a T9 torx screwdriver to remove a total of ten (10) 12mm screws from the main cover by turning the screwdriver counterclockwise.
  • The two screws above the screen assembly are deep so you may need a long screwdriver.

Use a T9 torx screwdriver to remove a total of ten (10) 12mm screws from the main cover by turning the screwdriver counterclockwise.

The two screws above the screen assembly are deep so you may need a long screwdriver.

Step 3

  • Grab the main cover and lift it up slightly.
  • Do not pull too hard—there is a cable connecting the cover to the printer.

Grab the main cover and lift it up slightly.

Do not pull too hard—there is a cable connecting the cover to the printer.

Step 4

  • Grab the base of the white ribbon cable connecting the cover to the base of the printer and pull it out.

Grab the base of the white ribbon cable connecting the cover to the base of the printer and pull it out.

Step 5

              Encoder Strip
  • Push the hook that is attached to the encoder strip towards the center of the printer.
  • Hold the hook pushed in and pull the strip off of the hook.
  • Repeat on the other side of the encoder strip.
  • During reassembly, the black triangle on the encoder strip should be on the right side of the printer.

Push the hook that is attached to the encoder strip towards the center of the printer.

Hold the hook pushed in and pull the strip off of the hook.

Repeat on the other side of the encoder strip.

During reassembly, the black triangle on the encoder strip should be on the right side of the printer.

Step 6

  • Carefully slide the encoder strip out from the carriage.

Carefully slide the encoder strip out from the carriage.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    David J

Member since: 01/24/2018

169 Reputation

                                      2 Guides authored                  



                       Badges:
                       2

Team

                       Cal Poly, Team S2-G4, Livingston Winter 2018                        

                                                  Member of Cal Poly, Team S2-G4, Livingston Winter 2018 



                    CPSU-LIVINGSTON-W18S2G4                     


                                            4 Members                     


                                            8 Guides authored