Hp Mini 110 1046Nr Memory Card Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 minutes

Sections

Battery
1 step
Memory Card Cover
1 step
Memory Card
1 step

Flags

BackHP Mini 110-1046NR
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery

Power-off the netbook fully before attempting to remove the battery.
Flip your netbook upside down, and locate the sliding tabs near the battery.
Slide both tabs inward so that the battery visibly moves away from the case of the computer.
Release the tabs and pull the battery out.

Power-off the netbook fully before attempting to remove the battery.

Flip your netbook upside down, and locate the sliding tabs near the battery.

Slide both tabs inward so that the battery visibly moves away from the case of the computer.

Release the tabs and pull the battery out.

1024

Step 2

              Memory Card Cover

Flip the netbook over so you are looking at the bottom, and locate the two screws that hold the memory card cover.
Next, take a Phillips PH1 screwdriver and unscrew the two screws.
These screws will not release from the cover once they are unscrewed.
If necessary, use the flat end of the spudger to assist in prying the cover away from the computer.

Flip the netbook over so you are looking at the bottom, and locate the two screws that hold the memory card cover.

Next, take a Phillips PH1 screwdriver and unscrew the two screws.

These screws will not release from the cover once they are unscrewed.

If necessary, use the flat end of the spudger to assist in prying the cover away from the computer.

Step 3

              Memory Card

Carefully push the clips to the side, away from the memory card.
Note: The memory module is spring-loaded and will pop out when the clips are detatched.
Slide the memory card straight out, holding it as shown to avoid getting skin oils on the electrical contacts.

Carefully push the clips to the side, away from the memory card.

Note: The memory module is spring-loaded and will pop out when the clips are detatched.

Slide the memory card straight out, holding it as shown to avoid getting skin oils on the electrical contacts.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 5 other contributors

                    Jared Cooper

Member since: 10/18/2013

649 Reputation

                                      5 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       Clemson, Team 14-1, Benson Fall 2013                        

                                                  Member of Clemson, Team 14-1, Benson Fall 2013 



                    CLEM-BENSON-F13S14G1                     


                                            3 Members                     


                                            12 Guides authored

Introduction#

What you need#

#

#

#

#

#

Team#

#

Introduction

What you need

Team