Difficulty

Easy

Steps

11

Time Required

                          20 minutes

Sections

1

  • HP m8226x Power Supply
  • 11 steps

Flags

0

  • BackHP Desktop

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              HP m8226x Power Supply
  • Turn off your computer and remove the power cord by pulling it straight out of its socket.

Turn off your computer and remove the power cord by pulling it straight out of its socket.

1024

Step 2

  • Remove the two screws holding the right (from the back) case door to the computer.

Remove the two screws holding the right (from the back) case door to the computer.

Step 3

  • Remove the side case door by pulling the tab towards the back of the computer with your hand.
  • Pull the door outward to remove it.

Remove the side case door by pulling the tab towards the back of the computer with your hand.

Pull the door outward to remove it.

Step 4

  • Remove the four screws holding in the power supply.

Remove the four screws holding in the power supply.

Step 5

  • Lay the computer on its side to make it easier to remove the wiring.

Lay the computer on its side to make it easier to remove the wiring.

Step 6

  • Remove the computer processor’s power cord by pinching the clip on the connector and pulling it straight out.

Remove the computer processor’s power cord by pinching the clip on the connector and pulling it straight out.

Step 7

  • Remove the power cord from the optical disc drive by pulling it straight out.

Remove the power cord from the optical disc drive by pulling it straight out.

Step 8

  • If the hard drive doesn’t have a SATA port connector then move to step 9.
  • Disconnect the SATA port connector from the hard drive by pulling it straight out.

If the hard drive doesn’t have a SATA port connector then move to step 9.

Disconnect the SATA port connector from the hard drive by pulling it straight out.

Step 9

  • If the hard drive has a 4-pin Molex connector, pinch the two clips on the connector and pull it straight out to remove it.

If the hard drive has a 4-pin Molex connector, pinch the two clips on the connector and pull it straight out to remove it.

Step 10

  • Remove the power to the motherboard by pinching the clip and pulling it straight out.

Remove the power to the motherboard by pinching the clip and pulling it straight out.

Step 11

  • Remove the power supply by pushing it out from the back of the computer and lifting it out of the computer.

Remove the power supply by pushing it out from the back of the computer and lifting it out of the computer.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Scott Fisher

Member since: 03/30/2016

101 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       Michigan Tech, Team 1-5, Lauer Spring 2016                        

                                                  Member of Michigan Tech, Team 1-5, Lauer Spring 2016 



                    MTU-LAUER-S16S1G5                     


                                            1 Member                     


                                            1 Guide authored