Difficulty

Moderate

Steps

6

Time Required

                          5 - 10 minutes

Sections

1

  • Fan
  • 6 steps

Flags

0

  • BackHP Laserjet Pro 200 Color MFP

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Fan
  • Turn the printer so that the front is facing to your left.
  • Flip the printer so that it is laying with its right side facing down and the bottom facing you.

Turn the printer so that the front is facing to your left.

Flip the printer so that it is laying with its right side facing down and the bottom facing you.

1024

Step 2

  • Remove the 8 mm screw on the top edge of the printer using a #2 Phillips head screwdriver.

Remove the 8 mm screw on the top edge of the printer using a #2 Phillips head screwdriver.

Step 3

  • There are three tabs along the back right corner of the printer underneath the panel shown (location is displayed in second picture).
  • Use a flathead screwdriver to depress these tabs while lightly pulling the panel towards you.
  • Begin with the upmost tab and move your way down, individually depressing the tabs while simultaneously pulling the panel towards you, removing it from the printer.

There are three tabs along the back right corner of the printer underneath the panel shown (location is displayed in second picture).

Use a flathead screwdriver to depress these tabs while lightly pulling the panel towards you.

Begin with the upmost tab and move your way down, individually depressing the tabs while simultaneously pulling the panel towards you, removing it from the printer.

Step 4

  • Rotate the printer so you are facing the open side.

Rotate the printer so you are facing the open side.

Step 5

  • Gently pull out the plug that supplies power to the fan from the socket on the circuit board.
  • Be careful when removing the plug as the components are fragile.

Gently pull out the plug that supplies power to the fan from the socket on the circuit board.

Be careful when removing the plug as the components are fragile.

Step 6

  • There are three tabs that hold the fan in place, as shown in the first picture. These steps may require an extra pair of hands in order to depress all the tabs.
  • Push each tab outwards from the fan.
  • Simultaneously pull the fan towards you until the fan clears the face of the printer.

There are three tabs that hold the fan in place, as shown in the first picture. These steps may require an extra pair of hands in order to depress all the tabs.

Push each tab outwards from the fan.

Simultaneously pull the fan towards you until the fan clears the face of the printer.

To reassemble your device, follow the instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 5 other contributors 


                    Kendall Gentzen

Member since: 04/18/2019

930 Reputation

                                      5 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Cal Poly, Team S9-G14, Maness Spring 2019                        

                                                  Member of Cal Poly, Team S9-G14, Maness Spring 2019 



                    CPSU-MANESS-S19S9G14                     


                                            4 Members                     


                                            5 Guides authored