Difficulty

Moderate

Steps

13

Time Required

                          15 minutes

Sections

3

  • Battery
  • 2 steps
  • Main Board
  • 9 steps
  • Joypad
  • 2 steps

Flags

0

  • BackHP iPAQ H2200

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Press and slide the battery cover tab to remove battery cover.

Press and slide the battery cover tab to remove battery cover.

1024

Step 2

  • Pull on the black tab to lift the battery out of the battery compartment.

Pull on the black tab to lift the battery out of the battery compartment.

Step 3

              Main Board
  • Remove the stylus by sliding it out of the slot.

Remove the stylus by sliding it out of the slot.

Step 4

  • Remove the CF card by sliding it out of the slot at the top of the device.

Remove the CF card by sliding it out of the slot at the top of the device.

Step 5

  • Press down and push the black side strips toward the top of the device to remove them.

Press down and push the black side strips toward the top of the device to remove them.

Step 6

  • Using the T5 Torx screwdriver, remove all six screws on the back and all screws on each side of the device.

Using the T5 Torx screwdriver, remove all six screws on the back and all screws on each side of the device.

Step 7

  • Remove the back faceplate by pushing and loosening the 4 side slots (2 on each side).

Remove the back faceplate by pushing and loosening the 4 side slots (2 on each side).

Step 8

  • Open the LCD connector, where the orange strip attaches to the main board.

Open the LCD connector, where the orange strip attaches to the main board.

Step 9

  • Carefully remove the orange LCD strip from the connector.

Carefully remove the orange LCD strip from the connector.

Step 10

  • Unscrew the 2 screws located at each top corner of the main board.

Unscrew the 2 screws located at each top corner of the main board.

Step 11

  • Remove the main board by pushing outward on the two tabs located on each side near the bottom of the device.

Remove the main board by pushing outward on the two tabs located on each side near the bottom of the device.

Step 12

              Joypad
  • Press on the four joypad tabs on the back, and push it through and out the front.

Press on the four joypad tabs on the back, and push it through and out the front.

Step 13

  • Push the new joypad through the hole; the tabs will lock it into place.

Push the new joypad through the hole; the tabs will lock it into place.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 9 other contributors 


                    Tyler Andrews

Member since: 01/13/2010

209 Reputation

                                      5 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Cal Poly, Team 4-12, Forte Winter 2010                        

                                                  Member of Cal Poly, Team 4-12, Forte Winter 2010 



                    CPSU-FORTE-W10S4G12                     


                                            3 Members                     


                                            5 Guides authored