Difficulty

Difficult

Steps

9

Time Required

                          15 - 20 minutes

Sections

1

  • Motherboard
  • 9 steps

Flags

0

  • BackHP eStation Zeen

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Motherboard
  • Remove the screw caps using the metal spudger.
  • Remove the four 6mm Phillips screws using the Phillips #0 screwdriver.

Remove the screw caps using the metal spudger.

Remove the four 6mm Phillips screws using the Phillips #0 screwdriver.

1024

Step 2

  • Unclip each side of the back cover by inserting the plastic opening tool and sliding it along the edge.
  • Remove the back panel by lifting the panel away from the device.

Unclip each side of the back cover by inserting the plastic opening tool and sliding it along the edge.

Remove the back panel by lifting the panel away from the device.

Step 3

  • Disconnect battery clip with plastic opening tool.
  • The clip is very fragile.

Disconnect battery clip with plastic opening tool.

The clip is very fragile.

Step 4

  • Disconnect the speaker terminal with the plastic opening tool.
  • The clip is very fragile.

Disconnect the speaker terminal with the plastic opening tool.

Step 5

  • Disconnect the the volume button clip with metal spudger tool.
  • The clip is fragile.

Disconnect the the volume button clip with metal spudger tool.

The clip is fragile.

Step 6

  • Disconnect the ground wire from the motherboard with tweezers.

Disconnect the ground wire from the motherboard with tweezers.

Step 7

  • Remove the two 6mm Phillips screws with Phillips #0 screwdriver.

Remove the two 6mm Phillips screws with Phillips #0 screwdriver.

Step 8

  • Pry off the clips that hold the motherboard down with the plastic spudger.

Pry off the clips that hold the motherboard down with the plastic spudger.

Step 9

  • Lift motherboard up to expose the ribbons on the back.
  • Lift the grey tabs to disconnect the ribbons with plastic spudger.

Lift motherboard up to expose the ribbons on the back.

Lift the grey tabs to disconnect the ribbons with plastic spudger.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 6 other contributors 


                    dalton hale

Member since: 09/26/2016

488 Reputation

                                      4 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       USF Tampa, Team 16-4, Eyestone Fall 2016                        

                                                  Member of USF Tampa, Team 16-4, Eyestone Fall 2016 



                    USFT-EYESTONE-F16S16G4                     


                                            4 Members                     


                                            10 Guides authored