Difficulty
Easy
Steps
3
Time Required
8 - 10 minutes
Sections
1
- Keyboard
- 3 steps
Flags
0
BackHP Envy x360 m6-w105dx
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Keyboard
- Make sure the laptop is powered off and disconnected from any outlets.
- Use the opening pick to lift up the eight rubber grips on the underside of the device.
- With the #1 Phillips screwdriver, remove the twelve 6mm screws from the back case.
Make sure the laptop is powered off and disconnected from any outlets.
Use the opening pick to lift up the eight rubber grips on the underside of the device.
With the #1 Phillips screwdriver, remove the twelve 6mm screws from the back case.
1024
Step 2
- Open the laptop and turn to the keyboard.
- Gently insert an opening pick into the edge of the keyboard panel, and slide around the keyboard lining until the clips have all been disengaged.
- Lift the keyboard panel from the bottom and carefully start to lift up.
- There are ribbon cables still connected on the under side of the the keyboard. Do not pull the keyboard away from the device.
Open the laptop and turn to the keyboard.
Gently insert an opening pick into the edge of the keyboard panel, and slide around the keyboard lining until the clips have all been disengaged.
Lift the keyboard panel from the bottom and carefully start to lift up.
There are ribbon cables still connected on the under side of the the keyboard. Do not pull the keyboard away from the device.
Step 3
- Gently lift the keyboard up from the bottom.
- Carefully open the locking flap of the three ZIF connectors and detach the three ribbon cables from the motherboard using your fingers.
- Do not remove the ZIF connectors by pulling on the wires, instead detach them by gently flipping up the plastic tabs located at the ends of the wiring.
- Fully remove the keyboard from the laptop and install your new keyboard.
Gently lift the keyboard up from the bottom.
Carefully open the locking flap of the three ZIF connectors and detach the three ribbon cables from the motherboard using your fingers.
Do not remove the ZIF connectors by pulling on the wires, instead detach them by gently flipping up the plastic tabs located at the ends of the wiring.
Fully remove the keyboard from the laptop and install your new keyboard.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 6 other contributors
Dalton Hancock
Member since: 01/24/2020
417 Reputation
3 Guides authored
Badges:
11
+8 more badges
Team
Embry-Riddle Aeronautical University, Team S5-G3, Watkins Spring 2020
Member of Embry-Riddle Aeronautical University, Team S5-G3, Watkins Spring 2020
ERAU-WATKINS-S20S5G3
4 Members
5 Guides authored
Alex Watkins - Feb 24, 2020
Reply
This guide is not complete.
Alquraini - Jan 4, 2021
Reply
Hi ..I need to buy keyboard for my laptop .. how can I get one please?
Janet Schexnayder - Feb 19, 2021
Reply
This seems to gloss over a lot of important steps and details, “Fully remove the keyboard from the laptop and install your new keyboard.“
Keyboard is attached by plastic tabs, not screws. How do I remove and install the new keyboard?
nurugee4luv - Nov 30, 2022
Reply
Hello please i need to buy keyboard for my laptop envy 15x360
Model 15-u280nb. Please how can i get it