Difficulty

Moderate

Steps

8

Time Required

                          8 minutes

Sections

3

  • Back Panel
  • 3 steps
  • Battery
  • 2 steps
  • Touchpad
  • 3 steps

Flags

0

  • BackHP Envy x360 m6-aq005dx

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Panel
  • Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top.

Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top.

1024

Step 2

  • Use a Torx T5 screwdriver to remove the six 5.1 mm screws.
  • Use a JIS #1 screwdriver to remove the two 7.2mm screws.

Use a Torx T5 screwdriver to remove the six 5.1 mm screws.

Use a JIS #1 screwdriver to remove the two 7.2mm screws.

Step 3

  • Use a plastic opening tool to pry open the case. Go slowly around the edge. You will hear popping noises, such are due to popping open the small joints that keep the cover attached.

Use a plastic opening tool to pry open the case. Go slowly around the edge. You will hear popping noises, such are due to popping open the small joints that keep the cover attached.

Step 4

              Battery
  • Use a JIS #1 screwdriver to remove the six 4.7 mm screws.

Use a JIS #1 screwdriver to remove the six 4.7 mm screws.

Step 5

  • Battery might cause a small electric shock.
  • Use tweezers to disconnect the battery from the motherboard.

Battery might cause a small electric shock.

Use tweezers to disconnect the battery from the motherboard.

Step 6

              Touchpad
  • Carefully, pull back the locking clip of the connector using a plastic opening tool and disconnect cable.

Carefully, pull back the locking clip of the connector using a plastic opening tool and disconnect cable.

Step 7

  • The red square contains two screws side by side.
  • Using a PH0 bit remove the 7 (2.8 mm) screws securing the touchpad to the device.

The red square contains two screws side by side.

Using a PH0 bit remove the 7 (2.8 mm) screws securing the touchpad to the device.

Step 8

  • Keep the ribbon cable from interfering with touchpad removal.
  • Use a plastic opening tool to pry up the touchpad.
  • Gently, pull out the touchpad from device.

Keep the ribbon cable from interfering with touchpad removal.

Use a plastic opening tool to pry up the touchpad.

Gently, pull out the touchpad from device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Darrin Smiley

Member since: 10/10/2017

261 Reputation

                                      2 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       USF Tampa, Team S13-G17, Cagle Fall 2017                        

                                                  Member of USF Tampa, Team S13-G17, Cagle Fall 2017 



                    USFT-CAGLE-F17S13G17                     


                                            4 Members                     


                                            7 Guides authored