Difficulty

Moderate

Steps

7

Time Required

                          3 minutes

Sections

3

  • Back Panel
  • 3 steps
  • Battery
  • 2 steps
  • Hard Drive
  • 2 steps

Flags

1

This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.

  • BackHP Envy x360 m6-aq005dx

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Panel
  • Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top.

Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top.

1024

Step 2

  • Use a Torx T5 screwdriver to remove the six 5.1 mm screws.
  • Use a JIS #1 screwdriver to remove the two 7.2mm screws.

Use a Torx T5 screwdriver to remove the six 5.1 mm screws.

Use a JIS #1 screwdriver to remove the two 7.2mm screws.

Step 3

  • Use a plastic opening tool to pry open the case. Go slowly around the edge. You will hear popping noises, such are due to popping open the small joints that keep the cover attached.

Use a plastic opening tool to pry open the case. Go slowly around the edge. You will hear popping noises, such are due to popping open the small joints that keep the cover attached.

Step 4

              Battery
  • Use a JIS #1 screwdriver to remove the six 4.7 mm screws.

Use a JIS #1 screwdriver to remove the six 4.7 mm screws.

Step 5

  • Battery might cause a small electric shock.
  • Use tweezers to disconnect the battery from the motherboard.

Battery might cause a small electric shock.

Use tweezers to disconnect the battery from the motherboard.

Step 6

              Hard Drive
  • Use a JIS J1 bit to remove the two 4.6 mm screws.

Use a JIS J1 bit to remove the two 4.6 mm screws.

Step 7

  • The red square is around the ribbon cable.
  • Use the plastic opening tool to open the black security connector. then pull the ribbon cable to disconnect it from the motherboard.

The red square is around the ribbon cable.

Use the plastic opening tool to open the black security connector. then pull the ribbon cable to disconnect it from the motherboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 6 other contributors 


                    Matthew Martin

Member since: 10/10/2017

711 Reputation

                                      5 Guides authored                  



                       Badges:
                       16







                                                        +13 more badges

Team

                       USF Tampa, Team S13-G17, Cagle Fall 2017                        

                                                  Member of USF Tampa, Team S13-G17, Cagle Fall 2017 



                    USFT-CAGLE-F17S13G17                     


                                            4 Members                     


                                            7 Guides authored