Difficulty
Easy
Steps
6
Time Required
4 minutes
Sections
2
- Back Cover
- 3 steps
- RAM
- 3 steps
Flags
0
BackHP Envy x360 15m-cn0011dx
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Make sure your device is fully powered off before attempting this guide.
What you need
Step 1
Back Cover
- Flip the laptop over to the back side.
Flip the laptop over to the back side.
1024
Step 2
- Remove the six 5.6 mm screws from the back cover using a Phillips #00 screwdriver.
- Remove the single 4.3 mm screw in the bottom middle section of the back cover using a T5 Torx screwdriver.
Remove the six 5.6 mm screws from the back cover using a Phillips #00 screwdriver.
Remove the single 4.3 mm screw in the bottom middle section of the back cover using a T5 Torx screwdriver.
Step 3
- Lift the back cover off the laptop.
Lift the back cover off the laptop.
Step 4
RAM
- Remove the metal plate that is covering the RAM.
Remove the metal plate that is covering the RAM.
Step 5
- Press the RAM placement tabs outward so the RAM stick pops upward.
Press the RAM placement tabs outward so the RAM stick pops upward.
Step 6
- Gently pull the RAM stick out of the RAM slot.
Gently pull the RAM stick out of the RAM slot.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Skylar Moore
Member since: 08/24/2022
619 Reputation
5 Guides authored
Badges:
5
+2 more badges
Team
Gateway, Team 1-4, Class Fall 2022
Member of Gateway, Team 1-4, Class Fall 2022
GCC-CLASS-F22S1G4
4 Members
5 Guides authored
