Hp Envy X360 15M Bq121Dx Cooling Fan Replacement Repair Guide

Difficulty

Moderate

Steps

8

Time Required

                          5 - 15 minutes            

Sections

1

• Cooling Fan
• 8 steps

Flags

Needs More Images

A few more images would make this guide’s procedures crystal clear.

• BackHP Envy x360 15m-bq121 dx

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Cooling Fan               

• Be sure the computer is powered off.
• Remove the rubber strip along the top of the backside of the computer.
• On the back panel of the device, remove the four (4) 2.5 mm screws at the top of the photo using a Phillips #0 screwdriver.
• Unscrew the three (3) screws at the bottom of the photo using a T5 Torx screwdriver.

Be sure the computer is powered off.

Remove the rubber strip along the top of the backside of the computer.

On the back panel of the device, remove the four (4) 2.5 mm screws at the top of the photo using a Phillips #0 screwdriver.

Unscrew the three (3) screws at the bottom of the photo using a T5 Torx screwdriver.

1024

Step 2

• To remove the back cover, use the spudger to lift up on the edges of the cover.
• Use a suction cup to assist in lifting the back cover
• Be sure to not damage any of the electronics on the inside.

To remove the back cover, use the spudger to lift up on the edges of the cover.

Use a suction cup to assist in lifting the back cover

Be sure to not damage any of the electronics on the inside.

Step 3

• Use the Philips #0 screwdriver to remove seven 2 mm screws from battery.

Use the Philips #0 screwdriver to remove seven 2 mm screws from battery.

Step 4

• Lift and pull the front of the battery up and out away from the connector to remove.

Lift and pull the front of the battery up and out away from the connector to remove.

Step 5

• Using a Philips #0 screwdriver, remove the three 2 mm screws located around the cooling fan as shown in this picture.
• The fan may have sharp edges so be careful upon removal.

Using a Philips #0 screwdriver, remove the three 2 mm screws located around the cooling fan as shown in this picture.

The fan may have sharp edges so be careful upon removal.

Step 6

• Remove the connector clip with the tweezers.

Remove the connector clip with the tweezers.

Step 7

• Remove the four spring loaded screws with a Philips #1 screwdriver.

Remove the four spring loaded screws with a Philips #1 screwdriver.

Step 8

• Remove the cooling fan.

Remove the cooling fan.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 

                    Fabien Perez                     

Member since: 02/13/2020

157 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       University of North Texas, Team S2-G1, Thomas Spring 2020                        

                                                  Member of University of North Texas, Team S2-G1, Thomas Spring 2020 



                    UNT-THOMAS-S20S2G1                     


                                            4 Members                     


                                            1 Guide authored