Difficulty

Moderate

Steps

8

Time Required

                          10 - 15 minutes

Sections

1

  • Battery
  • 8 steps

Flags

0

  • BackHP Envy x2 13-j002dx

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Remove five 4mm Phillips #0 screws securing the lower case to the HP Envy x2 13-j002dx.

Remove five 4mm Phillips #0 screws securing the lower case to the HP Envy x2 13-j002dx.

1024

Step 2

  • Use a Phillips #00 screwdriver to remove the two 3.5 mm screws from the bottom of the device—one on each side of the keyboard dock.

Use a Phillips #00 screwdriver to remove the two 3.5 mm screws from the bottom of the device—one on each side of the keyboard dock.

Step 3

  • Use a pair of tweezers to remove the screw covers on the bottom of the device.
  • Use a Phillips #0 screwdriver to remove the two 4mm screws.

Use a pair of tweezers to remove the screw covers on the bottom of the device.

Use a Phillips #0 screwdriver to remove the two 4mm screws.

Step 4

  • Use an opening pick to remove the plastic cover above the back stand.
  • Pry the cover off.
  • Use a Phillips #0 screwdriver to remove the four 4 mm screws.

Use an opening pick to remove the plastic cover above the back stand.

Pry the cover off.

Use a Phillips #0 screwdriver to remove the four 4 mm screws.

Step 5

  • Use an opening pick and a prying tool, and go around the device to remove the back cover from the rest of the assembly.

Use an opening pick and a prying tool, and go around the device to remove the back cover from the rest of the assembly.

Step 6

  • Unplug the battery from the motherboard.

Unplug the battery from the motherboard.

Step 7

  • Carefully pull up on the battery connector from the speaker.
  • Use a pair of tweezers and remove the taped down wire for the speaker.
  • Use a Phillips #00 screwdriver to remove the seven 3mm screws around the battery.

Carefully pull up on the battery connector from the speaker.

Use a pair of tweezers and remove the taped down wire for the speaker.

Use a Phillips #00 screwdriver to remove the seven 3mm screws around the battery.

Step 8

  • Carefully lift up and remove the battery.

Carefully lift up and remove the battery.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      5 other people completed this guide.

Author

                                      with 6 other contributors 


                    Aaron Page

Member since: 01/17/2019

418 Reputation

                                      1 Guide authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Eastern Washington University, Team S2-G4, Munoz Winter 2019                        

                                                  Member of Eastern Washington University, Team S2-G4, Munoz Winter 2019 



                    EWU-MUNOZ-W19S2G4                     


                                            2 Members                     


                                            1 Guide authored

Reed Jochimsen - Oct 4, 2020

Reply

For step 2, when I was taking the screws out, they were held in by the magnets that were on either side of them making it difficult to remove. I ended up having to use another magnet to get them out.