Hp Envy M6 P114Dx Battery Replacement Repair Guide

Difficulty

Moderate

Steps

6

Time Required

                          5 - 15 minutes            

Sections

2

• Back Panel
• 3 steps
• Battery
• 3 steps

Flags

0

• BackHP Envy m6-p114dx

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

Warning: if the battery appears swollen, is extremely hot, or has a bad smell be very cautious. At home removal can still be accomplished, but consulting a professional is recommended. The following link contains further information on swollen battery detection and repair: https://www.ifixit.com/News/11211/what-t…

What you need

Step 1

              Back Panel               

• Power the device off, unplug it, and ground yourself.

Power the device off, unplug it, and ground yourself.

1024

Step 2

• Remove the twelve screws in the back case using a Phillips #1 screwdriver.

Remove the twelve screws in the back case using a Phillips #1 screwdriver.

Step 3

• Carefully wedge an iFixit opening tool under the cover and slide it alongside the case to ensure that all clips are un-clipped.

Carefully wedge an iFixit opening tool under the cover and slide it alongside the case to ensure that all clips are un-clipped.

Step 4

              Battery               

• Remove the cable connecting the hard drive to the motherboard by carefully lifting the black tab, then pulling out the disconnected ribbon cable.

Remove the cable connecting the hard drive to the motherboard by carefully lifting the black tab, then pulling out the disconnected ribbon cable.

Step 5

• Remove the cable connecting the battery to the motherboard by gripping the fabric and pulling downward.
• The cable is connected next to the RAM cards.

Remove the cable connecting the battery to the motherboard by gripping the fabric and pulling downward.

The cable is connected next to the RAM cards.

Step 6

• Remove the six screws that hold the battery down with a Phillips #0 screwdriver.
• Once the screws are removed you should be able to easily lift up on the battery to remove it. (You may need to detach the ribbon cable glued to the battery )

Remove the six screws that hold the battery down with a Phillips #0 screwdriver.

Once the screws are removed you should be able to easily lift up on the battery to remove it. (You may need to detach the ribbon cable glued to the battery )

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 4 other contributors 

                    Taylor Cheney                     

Member since: 08/26/2019

511 Reputation

                                      4 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       Gateway, Team S1-G1, Saknee Fall 2019                        

                                                  Member of Gateway, Team S1-G1, Saknee Fall 2019 



                    GCC-SAKNEE-F19S1G1                     


                                            2 Members                     


                                            5 Guides authored