Hp Envy 700 030Qe Ram Replacement Repair Guide

Difficulty

Very easy

Steps

Time Required

                          3 minutes

Sections

RAM
3 steps

Flags

BackHP Envy 700-030qe
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

RAM

Make sure that you are wearing your anti-static wristband. This will prevent damaging any internal parts with any built up static electricity.
Unscrew the 10.5mm screw on the left of the desktop using your hand.
If it is too tight you may use a torx-head screwdriver or a flat-head screwdriver.

Make sure that you are wearing your anti-static wristband. This will prevent damaging any internal parts with any built up static electricity.

Unscrew the 10.5mm screw on the left of the desktop using your hand.

If it is too tight you may use a torx-head screwdriver or a flat-head screwdriver.

1024

Step 2

You can now slide off the side panel of the desktop.
You should now have an opening on the side of your computer as shown in the second picture.
The location of the RAM is highlighted in red.

You can now slide off the side panel of the desktop.

You should now have an opening on the side of your computer as shown in the second picture.

The location of the RAM is highlighted in red.

Step 3

Undo the clips on each end of the chip as shown in the second picture.
Then you may carefully remove the RAM chips by pulling them out by their the ends.
Make sure you pull the chips out by the ends and not grabbing the entire thing. This may damage the chips.
Remember the slots that you take the RAM chips from. You must put the two replacement chips in the same slots.

Undo the clips on each end of the chip as shown in the second picture.

Then you may carefully remove the RAM chips by pulling them out by their the ends.

Make sure you pull the chips out by the ends and not grabbing the entire thing. This may damage the chips.

Remember the slots that you take the RAM chips from. You must put the two replacement chips in the same slots.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Sam Wheeler

Member since: 10/01/2015

213 Reputation

                                      1 Guide authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Cal Poly, Team 5-9, Maness Fall 2015                        

                                                  Member of Cal Poly, Team 5-9, Maness Fall 2015 



                    CPSU-MANESS-F15S5G9                     


                                            4 Members                     


                                            10 Guides authored

Introduction#

What you need#

#

#

#

#

#

Team#

#

Introduction

What you need

Team