Hp Envy 700 030Qe Power Supply Replacement Repair Guide

Difficulty

Easy

Steps

9

Time Required

                          5 minutes            

Sections

1

• Power Supply
• 9 steps

Flags

0

• BackHP Envy 700-030qe

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Power Supply               

• Make sure that you are wearing your anti-static wristband. This will prevent damaging any internal parts with any built up static electricity.
• Unscrew the 10.5mm screw on the left of the desktop using your hand.
• If it is too tight you may use a torx-head screwdriver or a flat-head screwdriver.

Make sure that you are wearing your anti-static wristband. This will prevent damaging any internal parts with any built up static electricity.

Unscrew the 10.5mm screw on the left of the desktop using your hand.

If it is too tight you may use a torx-head screwdriver or a flat-head screwdriver.

1024

Step 2

• Remove the side panel by sliding it towards the back of the desktop and pulling up on it as shown.

Remove the side panel by sliding it towards the back of the desktop and pulling up on it as shown.

Step 3

• Remove the four 5mm screws holding the power supply in place with a T15 Torx screwdriver.

Remove the four 5mm screws holding the power supply in place with a T15 Torx screwdriver.

Step 4

• Undo the clasp which holds the power supply in place by pushing down on it.
• Pull out the power supply up and towards you.

Undo the clasp which holds the power supply in place by pushing down on it.

Pull out the power supply up and towards you.

Step 5

• Unplug the power cable going to the CD drive by pulling straight.

Unplug the power cable going to the CD drive by pulling straight.

Step 6

• Set aside the power supply on the left side of the computer.

Set aside the power supply on the left side of the computer.

Step 7

• Unplug the SATA interface power cable going to the hard drive by pulling straight up.

Unplug the SATA interface power cable going to the hard drive by pulling straight up.

Step 8

• Unplug the power cable going to the mother board by pulling straight up.

Unplug the power cable going to the mother board by pulling straight up.

Step 9

• Unplug the power cable going to the fan by pulling straight up.

Unplug the power cable going to the fan by pulling straight up.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 2 other contributors 

                    Yoav Rosenberg                     

Member since: 10/01/2015

294 Reputation

                                      2 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       Cal Poly, Team 5-9, Maness Fall 2015                        

                                                  Member of Cal Poly, Team 5-9, Maness Fall 2015 



                    CPSU-MANESS-F15S5G9                     


                                            4 Members                     


                                            10 Guides authored