Difficulty
Easy
Steps
5
Time Required
7 - 10 minutes
Sections
1
- LCD Screen
- 5 steps
Flags
0
BackHP Envy 4520
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
LCD Screen
- Lift the scanner bed.
Lift the scanner bed.
1024
Step 2
- Remove the T10, 13 mm center screw.
Remove the T10, 13 mm center screw.
Step 3
- Slide the front panel to the right, then lift the front panel upwards.
Slide the front panel to the right, then lift the front panel upwards.
Step 4
- Remove the large flat ribbon cable by pinching the top and bottom of the cable between thumb and index finger and pulling away from the mother board.
- Remove the small flat ribbon cable by pinching the top and bottom of the cable between thumb and index finger and pulling away from the mother board.
Remove the large flat ribbon cable by pinching the top and bottom of the cable between thumb and index finger and pulling away from the mother board.
Remove the small flat ribbon cable by pinching the top and bottom of the cable between thumb and index finger and pulling away from the mother board.
Step 5
- Remove the four T6, 7 mm mounting screws.
- Remove the LCD screen out of the plastic housing.
Remove the four T6, 7 mm mounting screws.
Remove the LCD screen out of the plastic housing.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 4 other contributors
Markell Parks
Member since: 09/26/2018
292 Reputation
2 Guides authored
Badges:
8
+5 more badges
Team
Eastern Washington University, Team S1-G6, Carnegie Fall 2018
Member of Eastern Washington University, Team S1-G6, Carnegie Fall 2018
EWU-CARNEGIE-F18S1G6
4 Members
8 Guides authored