Hp Envy 17M Ae111Dx Screen Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 - 20 minutes

Sections

Screen
4 steps

Flags

BackHP Envy 17m-ae111dx
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Screen

Orient your laptop so that the casing is laying on the table and the key board is facing you in the air.
If your screen is cracked, use a brush to remove excess glass shards.

Orient your laptop so that the casing is laying on the table and the key board is facing you in the air.

If your screen is cracked, use a brush to remove excess glass shards.

1024

Step 2

In this step, you will melt the adhesive around the outside of the screen.
Microwave the iOpener Device for 30 seconds. For more instructions on how to properly use the iOpener, please read through our iOpener instructions.
Lay the clear side of the iOpener down on the outer edge of the screen to melt the adhesive.
Make sure to wait two minutes before microwaving the iOpener again so as to prevent it from bursting.

In this step, you will melt the adhesive around the outside of the screen.

Microwave the iOpener Device for 30 seconds. For more instructions on how to properly use the iOpener, please read through our iOpener instructions.

Lay the clear side of the iOpener down on the outer edge of the screen to melt the adhesive.

Make sure to wait two minutes before microwaving the iOpener again so as to prevent it from bursting.

Step 3

Use the iFixit Opening Tool to pry open the screen.
Use the iFixit Opening Picks to scrape off the excess glue.
Make sure to keep something large wedged between the screen and the cover case to prevent pinching your fingers.

Use the iFixit Opening Tool to pry open the screen.

Use the iFixit Opening Picks to scrape off the excess glue.

Make sure to keep something large wedged between the screen and the cover case to prevent pinching your fingers.

Step 4

Disconnect the power wire.
The power wire is the smaller, black wire in the middle of the screen.
Disconnect the display wire.
The display wire is the wider cable on the left.
Remove the screen from the device.

Disconnect the power wire.

The power wire is the smaller, black wire in the middle of the screen.

Disconnect the display wire.

The display wire is the wider cable on the left.

Remove the screen from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Norma Nelson

Member since: 09/16/2019

115 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       Embry-Riddle Aeronautical University, Team S23-G5, McClure Fall 2019                        

                                                  Member of Embry-Riddle Aeronautical University, Team S23-G5, McClure Fall 2019 



                    ERAU-MCCLURE-F19S23G5                     


                                            4 Members                     


                                            5 Guides authored

imark7777777 - Nov 23, 2022

Thanks and by the way this is also equivalent to an hp envy 17-ae013ca

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team