Hp Elitepad 900 Battery Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          5 - 10 minutes            

Sections

2

• Front Panel Assembly
• 3 steps
• Battery
• 4 steps

Flags

3

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Missing Details

Some of this guide’s details are missing. Help users by adding tools, difficulty, or time.

• BackHP ElitePad 900

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Front Panel Assembly               

• Unscrew the two 2.8mm Phillips #000 screws near the power connector.

Unscrew the two 2.8mm Phillips #000 screws near the power connector.

1024

Step 2

• Use a suction cup to pull the display assembly up.

Use a suction cup to pull the display assembly up.

Step 3

• Use the tip of a spudger to disconnect the two display ZIF connectors.

Use the tip of a spudger to disconnect the two display ZIF connectors.

Step 4

              Battery               

• Remove the six 2.2mm Phillips #000 screws securing the battery to the device.

Remove the six 2.2mm Phillips #000 screws securing the battery to the device.

Step 5

• Disconnect and move the wires out of the way.

Disconnect and move the wires out of the way.

Step 6

• Lift cover.

Lift cover.

Step 7

• Slide out the battery.

Slide out the battery.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      11 other people completed this guide.                                             

Author

                                      with 3 other contributors 

                    Kyle Marques                     

Member since: 09/03/2015

847 Reputation

                                      6 Guides authored                  



                       Badges:
                       14







                                                        +11 more badges                           

Team

                       USF Tampa, Team 12-4, Blackwell Fall 2015                        

                                                  Member of USF Tampa, Team 12-4, Blackwell Fall 2015 



                    USFT-BLACKWELL-F15S12G4                     


                                            4 Members                     


                                            6 Guides authored                     

Dan Goo - Sep 15, 2016

Reply

Great Job took 10 min from start to finish!

Matt Brunk - Apr 1, 2020

Reply

One way to remove screen assembly without a suction cup is to use a piece of duct tape folded onto to itself leaving a small amount of the adhesive portion exposed. This creates a little handle. You can then stick it to assembly and lift it out easily.