Difficulty

Easy

Steps

5

Time Required

                          5 minutes

Sections

1

  • Battery
  • 5 steps

Flags

0

  • BackHP EliteBook x360 830 G7

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Batteries are important components of laptops, and without a functional battery your laptop might not perform in the desired manner. Batteries have a limited lifecycle, and after several charge cycles, they might start to drain quicker than usual. If this is happening with you, you might want to start by calibrating the battery. If the problem persists, you most likely need to replace the battery.

This guide will teach you how to replace your HP EliteBook x360 830 G7 battery safely and effectively. Make sure to power down your device before you start.

What you need

Step 1

              Battery
  • Turn the computer over so that the back is facing up.
  • Use a Torx T5 screwdriver to remove the three 9 mm screws from the hinge of the device.
  • Use a Torx T5 screwdriver to remove the two 7 mm screws from the left and right mid-section of the case.
  • Lift the backplate from the computer.

Turn the computer over so that the back is facing up.

Use a Torx T5 screwdriver to remove the three 9 mm screws from the hinge of the device.

Use a Torx T5 screwdriver to remove the two 7 mm screws from the left and right mid-section of the case.

Lift the backplate from the computer.

1024

Step 2

  • Use a nylon spudger to gently disconnect the battery’s bundled cable connector from the motherboard.
  • This bundled cable connector has a tab on each side. Insert the spudger between these tabs and the motherboard’s battery conncetor port, and gently push the battery connector out and away from the connector.

Use a nylon spudger to gently disconnect the battery’s bundled cable connector from the motherboard.

This bundled cable connector has a tab on each side. Insert the spudger between these tabs and the motherboard’s battery conncetor port, and gently push the battery connector out and away from the connector.

Step 3

  • Peel back both sides of the copper foil tape connected to the battery.

Peel back both sides of the copper foil tape connected to the battery.

Step 4

  • Use a JIS #1 screwdriver to remove the four 4 mm screws that secure the battery.

Use a JIS #1 screwdriver to remove the four 4 mm screws that secure the battery.

Step 5

  • Remove the battery from the laptop.

Remove the battery from the laptop.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Emily Kaplan

Member since: 03/21/2022

205 Reputation

                                      2 Guides authored                  



                       Badges:
                       3

Team

                       University of Alabama, Team 2-1, Bedsole Spring 2022                        

                                                  Member of University of Alabama, Team 2-1, Bedsole Spring 2022 



                    UA-BEDSOLE-S22S2G1                     


                                            4 Members                     


                                            5 Guides authored