Hp Elitebook X360 830 G5 Fan Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          20 - 35 minutes            

Sections

2

• Back Cover
• 3 steps
• Fan
• 4 steps

Flags

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs More Images

A few more images would make this guide’s procedures crystal clear.

• BackHP EliteBook x360 830 G5

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

Prior to beginning this repair, be sure to shut down the laptop and unplug the device from the charging cord.

What you need

Step 1

              Back Cover               

• With the T5 screw-bit and screwdriver, loosen the five captive screws on the bottom of the laptop.

With the T5 screw-bit and screwdriver, loosen the five captive screws on the bottom of the laptop.

1024

Step 2

• With a spudger or opening tool, pry above the computer’s hinges and separate the posterior edge and sides.

With a spudger or opening tool, pry above the computer’s hinges and separate the posterior edge and sides.

Step 3

• The back cover is held in place by magnetic strips.
• Remove the battery.

The back cover is held in place by magnetic strips.

Remove the battery.

Step 4

              Fan               

• With tweezers, pull back the retention tape that is attached to the fan cable.

With tweezers, pull back the retention tape that is attached to the fan cable.

Step 5

• Use your fingers to carefully disconnect the fan cable from the motherboard.

Use your fingers to carefully disconnect the fan cable from the motherboard.

Step 6

• Using a Phillips #1 screwdriver, loosen the three screws that secure the fan to the motherboard.

Using a Phillips #1 screwdriver, loosen the three screws that secure the fan to the motherboard.

Step 7

• With two fingers, carefully lift the left edge of the fan and remove it from the board.

With two fingers, carefully lift the left edge of the fan and remove it from the board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Lea Duben                     

Member since: 09/03/2021

305 Reputation

                                      3 Guides authored                  



                       Badges:
                       5





                                                        +2 more badges                           

Team

                       University of Alabama, Team 1-4, Bedsole Fall 2021                        

                                                  Member of University of Alabama, Team 1-4, Bedsole Fall 2021 



                    UA-BEDSOLE-F21S1G4                     


                                            4 Members                     


                                            5 Guides authored