Difficulty
Easy
Steps
4
Time Required
10 minutes
Sections
2
- Back Cover
- 2 steps
- Hard Drive
- 2 steps
Flags
0
BackHP EliteBook 820 G3
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- Remove the eleven 3 mm screws with a Phillips #00 screwdriver.
- Keep track of where the screw covers were attached to as there are four different sizes.
Remove the eleven 3 mm screws with a Phillips #00 screwdriver.
Keep track of where the screw covers were attached to as there are four different sizes.
1024
Step 2
- Remove the SD card blank and the single 3 mm screw beneath it using a Phillips #00 screwdriver.
- Lift off the back cover with your hands.
Remove the SD card blank and the single 3 mm screw beneath it using a Phillips #00 screwdriver.
Lift off the back cover with your hands.
Step 3
Hard Drive
- Remove the four 3 mm screws from the hard drive using a Phillips #00 screwdriver.
Remove the four 3 mm screws from the hard drive using a Phillips #00 screwdriver.
Step 4
- Slide the hard drive away from the system board connector to disconnect the hard drive from the system board.
- Place it in a static dissipative bag.
Slide the hard drive away from the system board connector to disconnect the hard drive from the system board.
Place it in a static dissipative bag.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Sarah Bisimwa
Member since: 08/25/2022
181 Reputation
2 Guides authored
Badges:
5
+2 more badges
Team
Gateway, Team 1-1, Class Fall 2022
Member of Gateway, Team 1-1, Class Fall 2022
GCC-CLASS-F22S1G1
4 Members
5 Guides authored