Difficulty
Moderate
Steps
10
Time Required
50 minutes
Sections
3
- Screen
- 4 steps
- Battery
- 2 steps
- Motherboard
- 4 steps
Flags
1
Better Introduction
Improve this guide by completing or revising its introduction.
BackHP Elite X2 1013 G3
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Screen
- Flip the device over so the base is facing the ceiling.
- Lift up the tablet stand.
- Remove the four 2 mm screws from the tablet using a T5 Torx screwdriver.
Flip the device over so the base is facing the ceiling.
Lift up the tablet stand.
Remove the four 2 mm screws from the tablet using a T5 Torx screwdriver.
1024
Step 2
- Flip the tablet over with the screen facing upwards.
- Place the suction handle in the center of the screen and slowly lift off the screen until it is at a 30 degree angle, starting by gently prying up the bottom.
- Do not pull the screen beyond a 30 degree angle. Additional internal components must be disconnected first.
Flip the tablet over with the screen facing upwards.
Place the suction handle in the center of the screen and slowly lift off the screen until it is at a 30 degree angle, starting by gently prying up the bottom.
Do not pull the screen beyond a 30 degree angle. Additional internal components must be disconnected first.
Step 3
- With the screen lifted at a 30 degree angle, gently disconnect the yellow ribbon cable at the end connected to the screen.
- Gently disconnect the orange ribbon cable at the end connected to the bottom plate.
With the screen lifted at a 30 degree angle, gently disconnect the yellow ribbon cable at the end connected to the screen.
Gently disconnect the orange ribbon cable at the end connected to the bottom plate.
Step 4
- Remove the screen from the tablet.
Remove the screen from the tablet.
Step 5
Battery
- Use the Phillips #00 screwdriver to remove the six 2 mm screws.
- Gently disconnect the two connectors.
Use the Phillips #00 screwdriver to remove the six 2 mm screws.
Gently disconnect the two connectors.
Step 6
- Lift the battery out of the housing.
Lift the battery out of the housing.
Step 7
Motherboard
- Remove five screws from the heat sink using a Phillips #0 screwdriver.
- Remove the heat sink from the tablet.
Remove five screws from the heat sink using a Phillips #0 screwdriver.
Remove the heat sink from the tablet.
Step 8
- Remove the single screw from the lightning cable connector using a Phillips #0 screwdriver.
- Lift the lightning cable connector out of the tablet.
Remove the single screw from the lightning cable connector using a Phillips #0 screwdriver.
Lift the lightning cable connector out of the tablet.
Step 9
- Remove the ten screws holding down the motherboard using a Phillips #0 screwdriver.
Remove the ten screws holding down the motherboard using a Phillips #0 screwdriver.
Step 10
- Remove the motherboard from the tablet.
Remove the motherboard from the tablet.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Maximillian Shaw Tiberghien
Member since: 09/20/2021
208 Reputation
2 Guides authored
Badges:
6
+3 more badges
Team
The Citadel Military College of South Carolina, Team 2-18, Eggleston Fall 2021
Member of The Citadel Military College of South Carolina, Team 2-18, Eggleston Fall 2021
CMCSC-EGGLESTON-F21S2G18
2 Members
3 Guides authored
