Hp Elite X2 1013 G3 Camera Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          20 minutes

Sections

Screen
4 steps
Camera
1 step

Flags

BackHP Elite X2 1013 G3
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Screen

Flip the device over so the base is facing the ceiling.
Lift up the tablet stand.
Remove the four 2 mm screws from the tablet using a T5 Torx screwdriver.

Flip the device over so the base is facing the ceiling.

Lift up the tablet stand.

Remove the four 2 mm screws from the tablet using a T5 Torx screwdriver.

1024

Step 2

Flip the tablet over with the screen facing upwards.
Place the suction handle in the center of the screen and slowly lift off the screen until it is at a 30 degree angle, starting by gently prying up the bottom.
Do not pull the screen beyond a 30 degree angle. Additional internal components must be disconnected first.

Flip the tablet over with the screen facing upwards.

Place the suction handle in the center of the screen and slowly lift off the screen until it is at a 30 degree angle, starting by gently prying up the bottom.

Do not pull the screen beyond a 30 degree angle. Additional internal components must be disconnected first.

Step 3

With the screen lifted at a 30 degree angle, gently disconnect the yellow ribbon cable at the end connected to the screen.
Gently disconnect the orange ribbon cable at the end connected to the bottom plate.

With the screen lifted at a 30 degree angle, gently disconnect the yellow ribbon cable at the end connected to the screen.

Gently disconnect the orange ribbon cable at the end connected to the bottom plate.

Step 4

Remove the screen from the tablet.

Remove the screen from the tablet.

Step 5

              Camera

Place the tip of an opening tool beneath the camera housing.
Slowly move the tool up and down until the camera pops off the laptop.
Remove the connector and lift the camera away from the laptop.

Place the tip of an opening tool beneath the camera housing.

Slowly move the tool up and down until the camera pops off the laptop.

Remove the connector and lift the camera away from the laptop.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Brian Sims

Member since: 09/20/2021

82 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       The Citadel Military College of South Carolina, Team 2-18, Eggleston Fall 2021                        

                                                  Member of The Citadel Military College of South Carolina, Team 2-18, Eggleston Fall 2021 



                    CMCSC-EGGLESTON-F21S2G18                     


                                            2 Members                     


                                            3 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team