Difficulty

Moderate

Steps

10

Time Required

                          15 - 20 minutes

Sections

2

  • Screen
  • 6 steps
  • Battery
  • 4 steps

Flags

0

  • BackHP Elite x2 1012 G2

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Screen
  • Make sure the device is turned off before starting.
  • Orient the device so the back is facing you, with the kickstand up.

Make sure the device is turned off before starting.

Orient the device so the back is facing you, with the kickstand up.

1024

Step 2

  • Remove the six 3mm Torx T5 screws underneath the kickstand.

Remove the six 3mm Torx T5 screws underneath the kickstand.

Step 3

  • Turn the device over so the screen is facing you.
  • Place a suction cup firmly onto a corner of the screen.
  • Lift up gently until you see the screen separate from the casing.
  • Repeat this process for all four corners.

Turn the device over so the screen is facing you.

Place a suction cup firmly onto a corner of the screen.

Lift up gently until you see the screen separate from the casing.

Repeat this process for all four corners.

Step 4

  • Lift the screen up and off of the device.
  • Pry each corner up first, otherwise you may damage or crack the screen.

Lift the screen up and off of the device.

Pry each corner up first, otherwise you may damage or crack the screen.

Step 5

  • Remove the two connectors on the back of the screen by lifting the connector tabs on the motherboard with a plastic opening tool and pulling gently.

Remove the two connectors on the back of the screen by lifting the connector tabs on the motherboard with a plastic opening tool and pulling gently.

Step 6

  • Remove the screen by gently lifting it off of the device.

Remove the screen by gently lifting it off of the device.

Step 7

              Battery
  • Orient the device so that the battery is closest to you.
  • The battery is the large, black rectangle at the bottom of the device.

Orient the device so that the battery is closest to you.

The battery is the large, black rectangle at the bottom of the device.

Step 8

  • Remove all six Phillips 3 mm screws around the battery by rotating in the counterclockwise direction with a Phillips screwdriver.

Remove all six Phillips 3 mm screws around the battery by rotating in the counterclockwise direction with a Phillips screwdriver.

Step 9

  • Remove the battery’s connector by pushing both sides of the tab towards yourself with a plastic opening tool.

Remove the battery’s connector by pushing both sides of the tab towards yourself with a plastic opening tool.

Step 10

  • Lift the battery out of the device.

Lift the battery out of the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      9 other people completed this guide.

Author

                                      with 5 other contributors 


                    Andy Velazquez

Member since: 04/18/2018

260 Reputation

                                      1 Guide authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Cal Poly, Team S18-G5, Livingston Spring 2018                        

                                                  Member of Cal Poly, Team S18-G5, Livingston Spring 2018 



                    CPSU-LIVINGSTON-S18S18G5                     


                                            4 Members                     


                                            13 Guides authored

scott kay - Oct 20, 2018

Reply

how do you test the battery? what voltage should it be maintaining?

tech25@hotmail.fr - Jul 17, 2021

Reply

Bien tout en image