Difficulty

Moderate

Steps

7

Time Required

                          20 - 25 minutes

Sections

2

  • Top Cover
  • 4 steps
  • Rollers
  • 3 steps

Flags

0

  • BackHP Deskjet D1660

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Top Cover
  • Remove the back two 14.0 mm Torx #10 screws.

Remove the back two 14.0 mm Torx #10 screws.

1024

Step 2

  • Lay the printer on its back.
  • Grab the paper tray by its right side and pull it to the left and up.

Lay the printer on its back.

Grab the paper tray by its right side and pull it to the left and up.

Step 3

  • Open the frontal access panel by lifting it from the top.
  • Similar to the paper tray, grab it from the right side and pull it to the left and up.

Open the frontal access panel by lifting it from the top.

Similar to the paper tray, grab it from the right side and pull it to the left and up.

Step 4

  • Take out the two frontal 14.0 mm Torx #10 screws.
  • Carefully lift the frontal cover.
  • Don’t lift it up aggressively. A strip will be attached to it.

Take out the two frontal 14.0 mm Torx #10 screws.

Carefully lift the frontal cover.

Don’t lift it up aggressively. A strip will be attached to it.

Step 5

              Rollers
  • Remove the five 13.0 mm Torx #10 screws found on top of the frame.
  • Remove the four 9.0 mm Torx #10 smaller screws.

Remove the five 13.0 mm Torx #10 screws found on top of the frame.

Remove the four 9.0 mm Torx #10 smaller screws.

Step 6

  • Lift the cover up using both of your hands.
  • Lift it carefully as a strip and motor will be connected to the bottom part of the printer.

Lift the cover up using both of your hands.

Lift it carefully as a strip and motor will be connected to the bottom part of the printer.

Step 7

  • Locate the rollers, which will be on the bottom of the metal frame that holds the carriage.
  • Grab the rollers and remove them by pulling them to one side and lifting them up.
  • Do the same for the other three.

Locate the rollers, which will be on the bottom of the metal frame that holds the carriage.

Grab the rollers and remove them by pulling them to one side and lifting them up.

Do the same for the other three.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Justin Taiki Fukada

Member since: 01/25/2014

846 Reputation

                                      7 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Cal Poly, Team 1-41, Maness Winter 2014                        

                                                  Member of Cal Poly, Team 1-41, Maness Winter 2014 



                    CPSU-MANESS-W14S1G41                     


                                            4 Members                     


                                            7 Guides authored