Hp Chromebook Cb2L Trackpad Replacement Repair Guide

Difficulty

Easy

Steps

5

Time Required

                          10 - 20 minutes            

Sections

1

• Trackpad
• 5 steps

Flags

0

• BackHP Chromebook CB2L

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Trackpad               

• Flip the Chromebook over, and starting at the top right or left hand corner of the large blue piece, use the plastic opening tool to remove it.
• Remove six 4.77mm screws using the Phillips #1 screwdriver.
• This part has fragile plastic connectors on it. Do not damage them.

Flip the Chromebook over, and starting at the top right or left hand corner of the large blue piece, use the plastic opening tool to remove it.

Remove six 4.77mm screws using the Phillips #1 screwdriver.

This part has fragile plastic connectors on it. Do not damage them.

1024

Step 2

• Starting at either the top left or right hand corner of the exposed metal piece, use the blue plastic opening tool to remove the back panel.

Starting at either the top left or right hand corner of the exposed metal piece, use the blue plastic opening tool to remove the back panel.

Step 3

• Remove four 3.42mm screws using the Phillips #1 screwdriver.
• Disconnect the battery from the motherboard.
• Remove the battery.

Remove four 3.42mm screws using the Phillips #1 screwdriver.

Disconnect the battery from the motherboard.

Remove the battery.

Step 4

• Remove four 2.57mm screws using the Phillips #1 screwdriver.
• Remove single 2.43mm screw using the Phillips #1 screwdriver.

Remove four 2.57mm screws using the Phillips #1 screwdriver.

Remove single 2.43mm screw using the Phillips #1 screwdriver.

Step 5

• Remove the metal piece along the bottom of the trackpad.
• Use the plastic opening tool to carefully flip the black piece on the ribbon cable holder then remove the ribbon cable.
• Push the trackpad out from the keyboard side.

Remove the metal piece along the bottom of the trackpad.

Use the plastic opening tool to carefully flip the black piece on the ribbon cable holder then remove the ribbon cable.

Push the trackpad out from the keyboard side.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Nathan Petrie                     

Member since: 10/31/2018

277 Reputation

                                      2 Guides authored                  



                       Badges:
                       3

Team

                       IUPUI, Team S1-G4, Harley Fall 2018                        

                                                  Member of IUPUI, Team S1-G4, Harley Fall 2018 



                    IUPUI-HARLEY-F18S1G4                     


                                            3 Members                     


                                            2 Guides authored