Difficulty

Moderate

Steps

6

Time Required

                          15 - 35 minutes

Sections

1

  • Screen
  • 6 steps

Flags

0

  • BackHP Chromebook 14-x013dx

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Note: The replacement of the screen does not require any prior disassembly of the laptop.

What you need

Step 1

              Screen
  • Remove lower left and right nylon flaps on the screen to remove the screws located underneath them.
  • The nylon strips on the side may be difficult to remove, as they are held on with adhesive. A spudger can be used to help remove these strips before removing with fingers.
  • Remove the two 2mm screws holding the bezel to the laptop case.

Remove lower left and right nylon flaps on the screen to remove the screws located underneath them.

The nylon strips on the side may be difficult to remove, as they are held on with adhesive. A spudger can be used to help remove these strips before removing with fingers.

Remove the two 2mm screws holding the bezel to the laptop case.

1024

Step 2

  • Gently pry around the edges of the display using a spudger to remove the bezel that borders the screen.

Gently pry around the edges of the display using a spudger to remove the bezel that borders the screen.

Step 3

  • Remove glued plastic at the bottom of the cover.

Remove glued plastic at the bottom of the cover.

Step 4

  • Once glue is separated, pop out the front cover by pulling upwards on the hinge.

Once glue is separated, pop out the front cover by pulling upwards on the hinge.

Step 5

  • Once the bezel has been removed, remove the four 5mm screws at the corners of the screen using a PH00 screwdriver.

Once the bezel has been removed, remove the four 5mm screws at the corners of the screen using a PH00 screwdriver.

Step 6

  • Before completely removing the screen, detach the connected located at the bottom of the screen.
  • The connection to be removed should have a barcode marking.

Before completely removing the screen, detach the connected located at the bottom of the screen.

The connection to be removed should have a barcode marking.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 4 other contributors 


                    NHerbert

Member since: 09/28/2017

572 Reputation

                                      5 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       USF Tampa, Team S3-G6, Nance Fall 2017                        

                                                  Member of USF Tampa, Team S3-G6, Nance Fall 2017 



                    USFT-NANCE-F17S3G6                     


                                            4 Members                     


                                            5 Guides authored