Difficulty

Moderate

Steps

6

Time Required

                          10 - 15 minutes

Sections

1

  • Battery
  • 6 steps

Flags

0

  • BackHP Chromebook 14-x010wm

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Remove the thirteen 5.7mm screws from the back of the laptop using a Phillips #00 screwdriver.
  • Remove rubber covers to reveal concealed screws, as needed.

Remove the thirteen 5.7mm screws from the back of the laptop using a Phillips #00 screwdriver.

Remove rubber covers to reveal concealed screws, as needed.

1024

Step 2

  • Flip the laptop over carefully and open the cover.
  • Use a plastic opening tool to pry open the front edge and along the sides of the keyboard cover to separate it from the computer’s base.
  • Lift the keyboard cover from the computer’s base carefully.

Flip the laptop over carefully and open the cover.

Use a plastic opening tool to pry open the front edge and along the sides of the keyboard cover to separate it from the computer’s base.

Lift the keyboard cover from the computer’s base carefully.

Step 3

  • Lifting the keyboard cover too much may damage the internal cables of the laptop.
  • Lift the black plastic flap, using a plastic opening tool, of the zero insertion force (ZIF) connector that holds the keyboard cable in place.
  • Disconnect the keyboard cable by slowly pulling it from the system board.
  • Lift the black plastic flap that holds the battery cable in place using a plastic opening tool.
  • Remove the battery cable by slowly pulling the plastic connector towards you.
  • Remove carefully and set aside keyboard panel.

Lifting the keyboard cover too much may damage the internal cables of the laptop.

Lift the black plastic flap, using a plastic opening tool, of the zero insertion force (ZIF) connector that holds the keyboard cable in place.

Disconnect the keyboard cable by slowly pulling it from the system board.

Lift the black plastic flap that holds the battery cable in place using a plastic opening tool.

Remove the battery cable by slowly pulling the plastic connector towards you.

Remove carefully and set aside keyboard panel.

Step 4

  • Flip the plastic flap holding the battery cable using a plastic opening tool.
  • Disconnect the battery cable by carefully pulling it from the system board.

Flip the plastic flap holding the battery cable using a plastic opening tool.

Disconnect the battery cable by carefully pulling it from the system board.

Step 5

  • Remove the seven M2xL3.0 screws from around the battery using a Phillips #00 screwdriver.

Remove the seven M2xL3.0 screws from around the battery using a Phillips #00 screwdriver.

Step 6

  • Peel the wire band off of the battery carefully.
  • Remove the battery by lifting slightly, then slowly pull it towards you.

Peel the wire band off of the battery carefully.

Remove the battery by lifting slightly, then slowly pull it towards you.

Follow these instructions in reverse order to reassemble your device.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Tyler Stover

Member since: 04/02/2019

133 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       IUPUI, Team S3-G3, Harley Spring 2019                        

                                                  Member of IUPUI, Team S3-G3, Harley Spring 2019 



                    IUPUI-HARLEY-S19S3G3                     


                                            3 Members                     


                                            2 Guides authored