Difficulty

Moderate

Steps

5

Time Required

Suggest a time??

Sections

1

  • Keyboard
  • 5 steps

Flags

Missing Details

Some of this guide’s details are missing. Help users by adding tools, difficulty, or time.

  • BackHP Chromebook 11-2210nr

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Keyboard
  • Position your closed laptop face down to remove the 9 visible 6mm screws using the Phillips #1 screwdriver.

Position your closed laptop face down to remove the 9 visible 6mm screws using the Phillips #1 screwdriver.

1024

Step 2

  • Using the metal spudger, remove the two rubber pads that are closer to the hinge of the laptop.
  • Remove the two additional 6mm screws located beneath the rubber pads using the Phillips #1 screwdriver.
  • The two bottom rubber pads do not contain screws, but you may check if you wish to be sure.

Using the metal spudger, remove the two rubber pads that are closer to the hinge of the laptop.

Remove the two additional 6mm screws located beneath the rubber pads using the Phillips #1 screwdriver.

The two bottom rubber pads do not contain screws, but you may check if you wish to be sure.

Step 3

  • Turn the Laptop over and with the metal spudger start to run it along the plastic seam to pry it off.
  • You will hear popping sounds when you are sliding the spudger along the device.
  • For an easier removal, start from the sides and work your way in to the corners.

Turn the Laptop over and with the metal spudger start to run it along the plastic seam to pry it off.

You will hear popping sounds when you are sliding the spudger along the device.

For an easier removal, start from the sides and work your way in to the corners.

Step 4

  • Carefully lift off the keyboard and gently place it towards you until the two ribbon wires become visible and place the keyboard down.
  • Locate where the two ribbon wires are being held in place by two chips.
  • This does not disconnect the keyboard from the laptop just yet.

Carefully lift off the keyboard and gently place it towards you until the two ribbon wires become visible and place the keyboard down.

Locate where the two ribbon wires are being held in place by two chips.

This does not disconnect the keyboard from the laptop just yet.

Step 5

  • Using the nylon spudger, lift the plastic clasps holding the two ribbon wires up to properly disconnect the wires.
  • It is recommended to use the nylon spudger for this step. Any metal can damage your motherboard.
  • This step completely disconnects the keyboard to allow safe removal and replacement.

Using the nylon spudger, lift the plastic clasps holding the two ribbon wires up to properly disconnect the wires.

It is recommended to use the nylon spudger for this step. Any metal can damage your motherboard.

This step completely disconnects the keyboard to allow safe removal and replacement.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Bridget Rosales

Member since: 10/02/2018

121 Reputation

                                      1 Guide authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       Sam Houston State, Team S11-G3, Blackburne Fall 2018                        

                                                  Member of Sam Houston State, Team S11-G3, Blackburne Fall 2018 



                    SHSU-BLACKBURNE-F18S11G3                     


                                            4 Members                     


                                            5 Guides authored