Hp 7 Plus 1301 Front And Back Camera Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          10 minutes

Sections

Front and Back Camera
7 steps

Flags

BackHP 7 PLUS 1301
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Front and Back Camera

Make sure the device is off and not plugged in before starting.
Using a Torx T5 screwdriver, remove the 3mm screws on all four corners of the device.

Make sure the device is off and not plugged in before starting.

Using a Torx T5 screwdriver, remove the 3mm screws on all four corners of the device.

1024

Step 2

Using the plastic opening tool, push in between the front, then slide it around.
Slide the plastic opening tool all the way around the tablet to separate the back cover.
Be careful when trying to remove the back as the screen can be damaged with excessive force.

Using the plastic opening tool, push in between the front, then slide it around.

Slide the plastic opening tool all the way around the tablet to separate the back cover.

Be careful when trying to remove the back as the screen can be damaged with excessive force.

Step 3

Continue sliding the plastic opening tool around the tablet until the cover fully separates from the device.
Remove the back cover.

Continue sliding the plastic opening tool around the tablet until the cover fully separates from the device.

Remove the back cover.

Step 4

Locate the front and rear cameras.

Locate the front and rear cameras.

Step 5

Using the opening tool, locate the rectangular gray connector near the camera and gently release its connection.
Lift the connector out and away from the board.
This will come out very easily so don’t use much force.

Using the opening tool, locate the rectangular gray connector near the camera and gently release its connection.

Lift the connector out and away from the board.

This will come out very easily so don’t use much force.

Step 6

Gently push the tabs on both sides until the front camera is loose.
Using your blunt tweezers, lift the front camera gently away from the board.

Gently push the tabs on both sides until the front camera is loose.

Using your blunt tweezers, lift the front camera gently away from the board.

Step 7

Using your angled tweezers, gently pry out the back camera.
The camera is held down with tape.
Lift the back camera out of its socket and gently pull out both cameras.

Using your angled tweezers, gently pry out the back camera.

The camera is held down with tape.

Lift the back camera out of its socket and gently pull out both cameras.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors

                    ahmed musleh

Member since: 02/05/2019

195 Reputation

                                      1 Guide authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       UC Davis, Team S20-G6, Lore Winter 2019                        

                                                  Member of UC Davis, Team S20-G6, Lore Winter 2019 



                    UCD-LORE-W19S20G6                     


                                            3 Members                     


                                            4 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team