Difficulty

Moderate

Steps

5

Time Required

                          9 minutes

Sections

2

  • Battery
  • 1 step
  • Hard Drive
  • 4 steps

Flags

0

  • BackHP Notebook 17-x027ds

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Flip the laptop so you can see the serial number and the four 7mm screws in all the corners.
  • Click the hinges by pushing them inward, which are located at the top of the laptop.
  • Remove the battery by pulling it out.

Flip the laptop so you can see the serial number and the four 7mm screws in all the corners.

Click the hinges by pushing them inward, which are located at the top of the laptop.

Remove the battery by pulling it out.

1024

Step 2

              Hard Drive
  • Remove the two pieces of black tape that are each covering a 7mm screw at the top corners of the laptop.
  • When removing the two black pieces of tape, keep the tape so you can place it back on the laptop again when reassembling.
  • Remove the fourteen 7mm JIS #1 screws.

Remove the two pieces of black tape that are each covering a 7mm screw at the top corners of the laptop.

When removing the two black pieces of tape, keep the tape so you can place it back on the laptop again when reassembling.

Remove the fourteen 7mm JIS #1 screws.

Step 3

  • Lift the bottom cover of the laptop with a metal spudger by wedging the sides first and going all around.
  • The cover is difficult to lift, so use extreme force.

Lift the bottom cover of the laptop with a metal spudger by wedging the sides first and going all around.

The cover is difficult to lift, so use extreme force.

Step 4

  • Disconnect the blue ends of the white ribbon cable by pulling the blue ends out of the connector.
  • The ribbon cable will still be connected to the rubber and just the ends will be disconnected.

Disconnect the blue ends of the white ribbon cable by pulling the blue ends out of the connector.

The ribbon cable will still be connected to the rubber and just the ends will be disconnected.

Step 5

  • Lift the black rubber cover containing the hard drive by lifting the right side of the rubber cover.
  • The white ribbon cable will still be connected to the rubber cover, so remove the hard drive out from under.

Lift the black rubber cover containing the hard drive by lifting the right side of the rubber cover.

The white ribbon cable will still be connected to the rubber cover, so remove the hard drive out from under.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 5 other contributors 


                    Bill Hoang

Member since: 09/18/2018

452 Reputation

                                      2 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       University of North Texas, Team S3-G1, Raign Fall 2018                        

                                                  Member of University of North Texas, Team S3-G1, Raign Fall 2018 



                    UNT-RAIGN-F18S3G1                     


                                            4 Members                     


                                            5 Guides authored