Difficulty

Easy

Steps

7

Time Required

                          5 - 6 minutes

Sections

3

  • Battery
  • 1 step
  • Back Panel
  • 4 steps
  • USB Port
  • 2 steps

Flags

0

  • BackHP 17-bs049dx

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • To remove the battery, simply push the tabs towards each other.
  • The battery will come out with force, be sure to keep anything fragile away from the laptop during this process.

To remove the battery, simply push the tabs towards each other.

The battery will come out with force, be sure to keep anything fragile away from the laptop during this process.

1024

Step 2

              Back Panel
  • Remove the four screws (13.7mm) with a Phillips #0 screwdriver.
  • Be sure to lift all four rubber tabs to access screws (7.51mm) underneath.
  • Rubber tabs will require force to access screws.

Remove the four screws (13.7mm) with a Phillips #0 screwdriver.

Be sure to lift all four rubber tabs to access screws (7.51mm) underneath.

Rubber tabs will require force to access screws.

Step 3

  • Use the Philips 0 screwdriver to unscrew the screws (7.51mm) that were underneath the battery.

Use the Philips 0 screwdriver to unscrew the screws (7.51mm) that were underneath the battery.

Step 4

  • Pull outwards on the disk reader to remove from main frame.
  • This removal will require force.
  • All screws must be removed before removing disk reader.

Pull outwards on the disk reader to remove from main frame.

This removal will require force.

All screws must be removed before removing disk reader.

Step 5

  • Lift back panel to access internal components.
  • You will need to use force to pry it open.

Lift back panel to access internal components.

You will need to use force to pry it open.

Step 6

              USB Port
  • Remove the two screws using a Phillips #0 screwdriver.

Remove the two screws using a Phillips #0 screwdriver.

Step 7

  • At both ends of the connector ribbon, unclip both connectors.
  • Gently remove the ribbon from the unlatched area.

At both ends of the connector ribbon, unclip both connectors.

Gently remove the ribbon from the unlatched area.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Logan McCarty

Member since: 10/01/2018

307 Reputation

                                      2 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       University of North Texas, Team S7-G2, Thompson Fall 2018                        

                                                  Member of University of North Texas, Team S7-G2, Thompson Fall 2018 



                    UNT-THOMPSON-F18S7G2                     


                                            6 Members                     


                                            7 Guides authored