Difficulty
Moderate
Steps
3
Time Required
5 minutes
Sections
2
- Battery
- 1 step
- Keyboard
- 2 steps
Flags
1
Better Introduction
Improve this guide by completing or revising its introduction.
BackHP 15-R263DX
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Battery
- Eject the battery from the computer by sliding the two clips on the bottom of the computer toward the center of the computer.
- Slide the battery out as shown in the picture.
Eject the battery from the computer by sliding the two clips on the bottom of the computer toward the center of the computer.
Slide the battery out as shown in the picture.
1024
Step 2
Keyboard
- Once keyboard is loose, do not immediately remove it from the computer. It is attached by a ribbon connector.
- Using a metal wedge tool, pry up along the top edge of the keyboard until all clips are disengaged and the keyboard is loose from the computer.
Once keyboard is loose, do not immediately remove it from the computer. It is attached by a ribbon connector.
Using a metal wedge tool, pry up along the top edge of the keyboard until all clips are disengaged and the keyboard is loose from the computer.
Step 3
- To disconnect the ribbon connector, flip up the black clip shown in the picture.
- Gently pull the ribbon until disconnected.
To disconnect the ribbon connector, flip up the black clip shown in the picture.
Gently pull the ribbon until disconnected.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Dilan Johnson
Member since: 02/12/2018
681 Reputation
4 Guides authored
Badges:
13
+10 more badges
Team
Washington State, Team S2-G3, Lobnitz Spring 2018
Member of Washington State, Team S2-G3, Lobnitz Spring 2018
WSU-LOBNITZ-S18S2G3
8 Members
7 Guides authored