Difficulty
Moderate
Steps
8
Time Required
5 - 15 minutes
Sections
3
- Battery
- 3 steps
- Back Panel
- 3 steps
- Speakers
- 2 steps
Flags
0
BackHP 15-ay078nr
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Orient the laptop so that the underside is facing up.
- Rotate the device so that the CD slot is in the upper left corner.
Orient the laptop so that the underside is facing up.
Rotate the device so that the CD slot is in the upper left corner.
1024
Step 2
- Put your fingers on the battery latch.
Put your fingers on the battery latch.
Step 3
- Using your fingers, push each battery latch simultaneously towards the middle.
- This releases the battery.
- Remove the battery from the laptop.
Using your fingers, push each battery latch simultaneously towards the middle.
This releases the battery.
Remove the battery from the laptop.
Step 4
Back Panel
- Pull off the two rubber feet on the underside of the device.
- Remove the twelve 9.5 mm screws from the underside of the device using a Phillips #2 screwdriver.
Pull off the two rubber feet on the underside of the device.
Remove the twelve 9.5 mm screws from the underside of the device using a Phillips #2 screwdriver.
Step 5
- Slide an opening pick around the edges between the back panel and the rest of the device to release the plastic retention clips that hold the panel in place.
Slide an opening pick around the edges between the back panel and the rest of the device to release the plastic retention clips that hold the panel in place.
Step 6
- Lift up on the panel to remove it completely from the device.
Lift up on the panel to remove it completely from the device.
Step 7
Speakers
- The speakers are located in the bottom right and left corners of the device.
- Use the opening pick to pry up the two plastic clip fasteners.
The speakers are located in the bottom right and left corners of the device.
Use the opening pick to pry up the two plastic clip fasteners.
Step 8
- Pull the cable speaker cable out of its housing on the motherboard.
Pull the cable speaker cable out of its housing on the motherboard.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Cameron Duffy
Member since: 10/25/2021
327 Reputation
3 Guides authored
Badges:
6
+3 more badges
Team
UMass Dartmouth, Team 3-1, Sinclaire Fall 2021
Member of UMass Dartmouth, Team 3-1, Sinclaire Fall 2021
UMASSD-SINCLAIRE-F21S3G1
3 Members
7 Guides authored