How To Replace The Wax Ring On A Toilet Repair Guide

Difficulty

Moderate

Steps

Time Required

                          20 minutes - 1 hour

Sections

Wax Ring
7 steps

Flags

BackToilet
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

A wax ring (wax O-ring, wax ring collar, wax ring seal) is a device that is essentially used to seal the connection between the toilet and the sewer line. This keeps gas and liquid from leaking from underneath the toilet, prevents damage to the flooring, and maintains hygienic disposal of waste. Additionally, a wax ring helps prevent the growth of mold and bacteria around your toilet.

Before you begin, make sure to wear gloves and closed-toed shoes. It will be very useful to have someone near to assist, as a toilet can be heavy and awkward to lift.

What you need

Step 1

              Wax Ring

Turn off the water.
You do not want to forget this step.

Turn off the water.

You do not want to forget this step.

1024

Step 2

Disconnect the hose from the toilet by unscrewing the white plastic connector.
Excess water will spill out of this pipe, so have a bucket or rag nearby to catch it!

Disconnect the hose from the toilet by unscrewing the white plastic connector.

Excess water will spill out of this pipe, so have a bucket or rag nearby to catch it!

Step 3

Remove the plastic bolt protectors on either side of the base of the toilet.
Using a wrench, remove the nuts and washers from the bottom of the toilet where it’s bolted to the floor.

Remove the plastic bolt protectors on either side of the base of the toilet.

Using a wrench, remove the nuts and washers from the bottom of the toilet where it’s bolted to the floor.

Step 4

Lift the toilet up from the floor.
Use caution when lifting it, it’s going to be heavy!
Set the toilet off to the side.

Lift the toilet up from the floor.

Use caution when lifting it, it’s going to be heavy!

Set the toilet off to the side.

Step 5

Remove the old wax ring and any debris from the toilet pipe in the floor where the toilet was, being sure not to let any debris fall down the pipe.
It may be nice to wear gloves for this step, as the old wax ring will be a bit dirty.

Remove the old wax ring and any debris from the toilet pipe in the floor where the toilet was, being sure not to let any debris fall down the pipe.

It may be nice to wear gloves for this step, as the old wax ring will be a bit dirty.

Step 6

Place new ring in the proper position for your toilet to rest on.
Carefully position the toilet back over the hole, paying attention to the bolts.

Place new ring in the proper position for your toilet to rest on.

Carefully position the toilet back over the hole, paying attention to the bolts.

Step 7

Tighten the nuts and bolts on each side of the toilet and replace the bolt-protectors.

Tighten the nuts and bolts on each side of the toilet and replace the bolt-protectors.

Make sure you wash your hands!

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Ahna Hensley

Member since: 01/18/2021

145 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       Eastern Washington University, Team S1-G21, Carnegie Winter 2021                        

                                                  Member of Eastern Washington University, Team S1-G21, Carnegie Winter 2021 



                    EWU-CARNEGIE-W21S1G21                     


                                            1 Member                     


                                            1 Guide authored

Introduction#

What you need#

Team#

Introduction

What you need

Team