Difficulty
Easy
Steps
6
Time Required
4 minutes
Sections
1
- Disc
- 6 steps
Flags
0
BackBicycles
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Disc
- Unscrew the exterior bell housing by rotating clockwise, then remove the housing.
Unscrew the exterior bell housing by rotating clockwise, then remove the housing.
1024
Step 2
- Rotate the parallel bars clockwise until they separate from the rod they’re mounted on.
Rotate the parallel bars clockwise until they separate from the rod they’re mounted on.
Step 3
- Remove the rubber discs.
- Grab your new rubber discs and insert one at each end of the parallel bars.
- Make sure center of the rubber discs are held in place by the pins.
Remove the rubber discs.
Grab your new rubber discs and insert one at each end of the parallel bars.
Make sure center of the rubber discs are held in place by the pins.
Step 4
- Test and rotate the discs with your finger to see if it is the appropriate size.
- If the disc does not rotate easily, change the size of your metal disc to a narrower one.
Test and rotate the discs with your finger to see if it is the appropriate size.
If the disc does not rotate easily, change the size of your metal disc to a narrower one.
Step 5
- Rotate the parallel bars counterclockwise, into their original position.
Rotate the parallel bars counterclockwise, into their original position.
Step 6
- Replace the exterior housing and rotate it counterclockwise until it’s fully secure.
Replace the exterior housing and rotate it counterclockwise until it’s fully secure.
Your bell should now be ringing like new!
Cancel: I did not complete this guide.
Author
with 1 other contributor
Susan
Member since: 01/19/2022
133 Reputation
1 Guide authored
Badges:
2
Team
York University, Team N-10, O'Regan Winter 2022
Member of York University, Team N-10, O'Regan Winter 2022
YORK-O'REGAN-W22SNG10
1 Member
1 Guide authored