Difficulty

Easy

Steps

6

Time Required

                          15 minutes

Sections

1

  • How to Repair a Scraping Door
  • 6 steps

Flags

0

  • BackRéparation porte

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              How to Repair a Scraping Door
  • Inspect the door itself in order to check for the main reason for the scraping. If there are any loose screws, make sure to tighten them. If the door still scrapes, continue with the following steps

Inspect the door itself in order to check for the main reason for the scraping. If there are any loose screws, make sure to tighten them. If the door still scrapes, continue with the following steps

1024

Step 2

  • Use both your hammer and your screwdriver in order to push the door pin out of the hinges. Begin with the top pin, and continue using this method for the bottom hinge, and finish this step by removing the middle hinge last

Use both your hammer and your screwdriver in order to push the door pin out of the hinges. Begin with the top pin, and continue using this method for the bottom hinge, and finish this step by removing the middle hinge last

Step 3

  • Carefully remove the door from its frame, and carefully set it on its side in a secure place.

Carefully remove the door from its frame, and carefully set it on its side in a secure place.

Step 4

  • Retrieve your sanding block and use it to carefully scrape the bottom portion of the door. Make sure to occasionally check if the door will fit in the frame.

Retrieve your sanding block and use it to carefully scrape the bottom portion of the door. Make sure to occasionally check if the door will fit in the frame.

Step 5

  • Carefully place the door back into its frame. While keeping a steady hand on the door, use your hammer and screwdriver to re-insert the door pins. Begin in reverse order from how you removed the pins.

Carefully place the door back into its frame. While keeping a steady hand on the door, use your hammer and screwdriver to re-insert the door pins. Begin in reverse order from how you removed the pins.

Step 6

  • Once all the pins are in their former areas, make sure to recheck the door to see if the scraping has ceased. If there is still any scraping, redo the previous steps until you are completely satisfied.

Once all the pins are in their former areas, make sure to recheck the door to see if the scraping has ceased. If there is still any scraping, redo the previous steps until you are completely satisfied.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Erynne Moore

Member since: 02/07/2019

133 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       McKendree University, Team S1-G10, Quinn Spring 2019                        

                                                  Member of McKendree University, Team S1-G10, Quinn Spring 2019 



                    MCKU-QUINN-S19S1G10                     


                                            1 Member                     


                                            2 Guides authored