Difficulty
Moderate
Steps
6
Time Required
5 - 10 minutes
Sections
1
- How to Open the Left Handle of the Backbone One
- 6 steps
Flags
0
BackBackbone One
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Unfasten the screws
- Use a Phillips screwdriver to remove the four 5.9 mm-long screws.
Use a Phillips screwdriver to remove the four 5.9 mm-long screws.
1024
Step 2
Rotate the upper cover
- Lift up the upper part of the controller.
- Swing over the upper cover and place it on the controller case.
- Take care that the interconnecting cable has no tension.
Lift up the upper part of the controller.
Swing over the upper cover and place it on the controller case.
Take care that the interconnecting cable has no tension.
Step 3
Remove the protective tape
- Use a pair of tweezers to remove the yellow protective tape which is placed over the interconnect cable connector.
Use a pair of tweezers to remove the yellow protective tape which is placed over the interconnect cable connector.
Step 4
Open the ZIF connector
- Use the tip of an opening pick to open the gray flap of the ZIF connector by pushing it upwards.
Use the tip of an opening pick to open the gray flap of the ZIF connector by pushing it upwards.
Step 5
Disconnect the interconnect cable
- Use your fingers to disconnect the interconnect cable from its connector.
Use your fingers to disconnect the interconnect cable from its connector.
Step 6
- Remove the upper half of the left controller assembly.
Remove the upper half of the left controller assembly.
To reassemble your device, follow these instructions in reverse order.Opening didn’t go as planned? Answers community for help.
Cancel: I did not complete this guide.
Author
Adriana Zwink
Member since: 12/18/2019
36,607 Reputation
167 Guides authored
Badges:
34
+31 more badges
Team
iFixit
Member of iFixit
Community
141 Members
15,772 Guides authored