How To Open The Huawei Watch Gt 3 46Mm For Repairs Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 - 20 minutes

Sections

How to open the Huawei Watch GT 3 (46mm) for Repairs
4 steps

Flags

BackHuawei Watch GT 3
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Remove the watch band

Before starting repairs, take your watch off the charger and power it down.
Remove the watch band.

Before starting repairs, take your watch off the charger and power it down.

Remove the watch band.

1024

Step 2

              Unfasten the back cover screws

Remove the four 3.7 mm-long Torx T2 screws securing the back cover.

Remove the four 3.7 mm-long Torx T2 screws securing the back cover.

Step 3

              Pry up the rear panel

Insert the edge of a spudger into the the loudspeaker opening at the bottom edge of your watch.
When prying up the back cover put a finger on top or the edge of it and hold it down. Too much force during the prying procedure may lead to popping off the back cover too quickly and tearing the rear panel assembly cable.
The plastic clamps holding the back cover in place sit very tight and may require some force during the prying procedure.
Use a spudger to pry up the rear panel of your Huawei watch GT 3.
Don’t try to remove the back cover assembly all the way yet, it’s still connected to the daughterboard.

Insert the edge of a spudger into the the loudspeaker opening at the bottom edge of your watch.

When prying up the back cover put a finger on top or the edge of it and hold it down. Too much force during the prying procedure may lead to popping off the back cover too quickly and tearing the rear panel assembly cable.

The plastic clamps holding the back cover in place sit very tight and may require some force during the prying procedure.

Use a spudger to pry up the rear panel of your Huawei watch GT 3.

Don’t try to remove the back cover assembly all the way yet, it’s still connected to the daughterboard.

Step 4

              Swing open the rear panel assembly

Carefully swing the rear panel assembly open to an upward position.
To avoid straining the rear panel assembly cable during following repair steps you can lean it against an object of your choice.

Carefully swing the rear panel assembly open to an upward position.

To avoid straining the rear panel assembly cable during following repair steps you can lean it against an object of your choice.

If possible, turn on your device and test your repair before installing new adhesive and resealing.

Compare your new replacement part to the original part—you may need to transfer remaining components or remove adhesive backings from the new part before installing.

To reassemble your device, follow these instructions in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.

Cancel: I did not complete this guide.

Author

                    Dominik Schnabelrauch

Member since: 11/23/2016

158,135 Reputation

                                      649 Guides authored                  



                       Badges:
                       40







                                                        +37 more badges

Team

                       iFixit                        

                                                  Member of iFixit 



                    Community                     


                                            141 Members                     


                                            15,772 Guides authored

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team