Difficulty

Easy

Steps

4

Time Required

                          5 - 10 minutes

Sections

1

  • bObsweep’s cover
  • 4 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackbObsweep Robotic Vacuum Cleaner

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              bObsweep's cover
  • Flip Bob over and remove the 7 screws around which hold the cover together.
  • Remove the main brush. Unscrew the holder, and lift the brush out. Reminder: Keep this screw separate from the others so you can use it later to reinstall.
  • Depending on your model, there may be only 6 screws installed on bObsweep.

Flip Bob over and remove the 7 screws around which hold the cover together.

Remove the main brush. Unscrew the holder, and lift the brush out. Reminder: Keep this screw separate from the others so you can use it later to reinstall.

Depending on your model, there may be only 6 screws installed on bObsweep.

1024

Step 2

  • There are two screw holes inside the brush compartment: one in the centre, one on the left end. Remove both and keep aside for reassembly.
  • There are five more screws around bObsweep’s edges. Two are installed at the top and bottom, and one on the right end of the main brush.

There are two screw holes inside the brush compartment: one in the centre, one on the left end. Remove both and keep aside for reassembly.

There are five more screws around bObsweep’s edges. Two are installed at the top and bottom, and one on the right end of the main brush.

Step 3

  • Flip bOb back over so you can see the screen. Lift the cover up to reveal bObsweep’s main board.
  • Detach the power inlet from the cover. Grip and slide it out.

Flip bOb back over so you can see the screen. Lift the cover up to reveal bObsweep’s main board.

Detach the power inlet from the cover. Grip and slide it out.

Step 4

  • Remove three circuit plugs from the motherboard. Pinch the small white tab on the side of each circuit plug and pull straight up to release each from the motherboard.
    1. On the bottom left corner: a small connector with red, black and white wires.
    1. One thick white wire that attaches on the right side of the previous connector.
    1. On the top edge of bOb’s motherboard: a wide multicoloured connector.
  • Place the cover aside and begin your repair.

Remove three circuit plugs from the motherboard. Pinch the small white tab on the side of each circuit plug and pull straight up to release each from the motherboard.

  1. On the bottom left corner: a small connector with red, black and white wires.

  2. One thick white wire that attaches on the right side of the previous connector.

  3. On the top edge of bOb’s motherboard: a wide multicoloured connector.

Place the cover aside and begin your repair.

To reassemble your bObsweep, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 1 other contributor 


                    Tatiana

Member since: 06/28/2014

737 Reputation

                                      17 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Gerqui Vila - Apr 15, 2020

Reply

Change battery, and still does what it did before. Battery life is one bar only, and the moment u push start it shuts right off. Even after charging all day. Please help