Difficulty

Moderate

Steps

7

Time Required

                          30 - 40 minutes

Sections

1

  • How to Fix a Razer Naga Trinity Click Button
  • 7 steps

Flags

Missed a Step

Oops! This guide is currently missing some important steps.

  • BackRazer Naga Trinity

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Each mouse has a fixed maximum number of clicks. When the mouse is used for a long time, the clicker of the mouse will have problems. At this time, you will need to manually disassemble the mouse for maintenance.

Make sure you do not use too much force; the parts inside the mouse are sometimes very easy to damage.

This guide is not only applicable to this model,—other mice can also be repaired with this guide, but the internal structure may be different.

What you need

Step 1

              How to Fix a Razer Naga Trinity Click Button
  • Remove the three pads from the bottom of the mouse.
  • Remove the four screws beneath the pads using a JIS #1 screwdriver.

Remove the three pads from the bottom of the mouse.

Remove the four screws beneath the pads using a JIS #1 screwdriver.

1024

Step 2

  • Press the top of mouse and pull back to disconnect the mouse shell.
  • Pull out the cord that connects the RGB button.

Press the top of mouse and pull back to disconnect the mouse shell.

Pull out the cord that connects the RGB button.

Step 3

  • Remove the right shell.
  • Disconnect the cable connecting the left shell to the mouse.
  • Remove the left shell.

Remove the right shell.

Disconnect the cable connecting the left shell to the mouse.

Remove the left shell.

Step 4

  • Use a safety pin to unlatch the clicker buttons.

Use a safety pin to unlatch the clicker buttons.

Step 5

  • Insert the open safety pin to lift one side latch slightly.
  • Do not open the whole part.
  • Repeat for the other side.

Insert the open safety pin to lift one side latch slightly.

Do not open the whole part.

Repeat for the other side.

Step 6

  • Remove the clicker and white pin.
  • Gently press the middle part of the copper sheet until it unhooks itself.
  • Pull the bended part of the copper sheet back.

Remove the clicker and white pin.

Gently press the middle part of the copper sheet until it unhooks itself.

Pull the bended part of the copper sheet back.

Step 7

  • Reassemble the copper sheet with the white pin seated properly.
  • Push the spring down into its place using a spudger.
  • You will hear a click sound if you successfully assemble it.

Reassemble the copper sheet with the white pin seated properly.

Push the spring down into its place using a spudger.

You will hear a click sound if you successfully assemble it.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 1 other contributor 


                    Haoran Ke

Member since: 01/13/2022

220 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       York University, Team S-12, Woodhouse Winter 2022                        

                                                  Member of York University, Team S-12, Woodhouse Winter 2022 



                    YORK-WOODHOUSE-W22SSG12                     


                                            1 Member                     


                                            1 Guide authored