Difficulty
Easy
Steps
4
Time Required
3 - 6 minutes
Sections
1
- Back Seat Light
- 4 steps
Flags
Featured Student Guide
This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.
BackHover-1 XLS
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Seat Light
- Remove the seat by removing the six 16mm screws with a Phillips #2 screwdriver.
- Remember that the seat is still connected by the wiring once you unscrew it. Pulling too hard can damage the connector.
Remove the seat by removing the six 16mm screws with a Phillips #2 screwdriver.
Remember that the seat is still connected by the wiring once you unscrew it. Pulling too hard can damage the connector.
1024
Step 2
- Disconnect the wires by pushing the levers on either side of the connector and on top.
- Remove the seat from the bike.
Disconnect the wires by pushing the levers on either side of the connector and on top.
Remove the seat from the bike.
Step 3
- Use a Phillips #2 screwdriver to remove the four 10mm screws on the bottom of the back seat.
Use a Phillips #2 screwdriver to remove the four 10mm screws on the bottom of the back seat.
Step 4
- Pull the light from behind the bottom of the seat frame. Pull the wiring all the way through.
Pull the light from behind the bottom of the seat frame. Pull the wiring all the way through.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Christian Roberts
Member since: 01/24/2019
248 Reputation
1 Guide authored
Badges:
9
+6 more badges
Team
Cal Poly, Team S1-G2, White Winter 2019
Member of Cal Poly, Team S1-G2, White Winter 2019
CPSU-WHITE-W19S1G2
3 Members
6 Guides authored
