Hover 1 Titan Charge Port Replacement Repair Guide

Difficulty

Easy

Steps

6

Time Required

                          10 - 20 minutes            

Sections

2

• Bottom Left Panel
• 3 steps
• Charge Port
• 3 steps

Flags

0

• BackHover-1 Titan

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Bottom Left Panel               

• Flip the hoverboard so the bottom is facing up.
• The left side is the side that has the charge port. There is also an “L” on the metal plate underneath the wires.

Flip the hoverboard so the bottom is facing up.

The left side is the side that has the charge port. There is also an “L” on the metal plate underneath the wires.

1024

Step 2

• Using a Phillips #1 screwdriver, remove the two 14 mm screws located closest to the center of the hoverboard.
• Using a Phillips #1 screwdriver, remove the four 12 mm screws located in the middle of the panel.
• Using a Phillips #1 screwdriver, remove two 15 mm screws located closest to the wheel.

Using a Phillips #1 screwdriver, remove the two 14 mm screws located closest to the center of the hoverboard.

Using a Phillips #1 screwdriver, remove the four 12 mm screws located in the middle of the panel.

Using a Phillips #1 screwdriver, remove two 15 mm screws located closest to the wheel.

Step 3

• Grip the bottom left panel and lift up to remove.

Grip the bottom left panel and lift up to remove.

Step 4

              Charge Port               

• Unplug the red and black charge port wire from the motherboard by squeezing the connector located at the top right of the motherboard and pulling the connector away from the board.

Unplug the red and black charge port wire from the motherboard by squeezing the connector located at the top right of the motherboard and pulling the connector away from the board.

Step 5

• Use an adjustable wrench to loosen the 14 mm nut and lift it off the charge port.

Use an adjustable wrench to loosen the 14 mm nut and lift it off the charge port.

Step 6

• Remove the old charge port by pulling the wires all the way through the panel.
• Replace the old charge port with the new charge port.

Remove the old charge port by pulling the wires all the way through the panel.

Replace the old charge port with the new charge port.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 

                    Jessica Ouyang                     

Member since: 10/08/2018

604 Reputation

                                      4 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges                           

Team

                       Cal Poly, Team S15-G4, White Fall 2018                        

                                                  Member of Cal Poly, Team S15-G4, White Fall 2018 



                    CPSU-WHITE-F18S15G4                     


                                            4 Members                     


                                            10 Guides authored