Difficulty
Easy
Steps
3
Time Required
4 minutes
Sections
2
- Bottom Case
- 2 steps
- Front Bumper LED
- 1 step
Flags
0
BackHover-1 Superstar
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Bottom Case
- Flip your Hover-1 Superstar device upside down.
- Using a Phillips #1 screwdriver, remove all twenty of the 18mm screws holding the case onto the device.
- Remove the bottom case. Be careful of the connector holding the case and the device together.
Flip your Hover-1 Superstar device upside down.
Using a Phillips #1 screwdriver, remove all twenty of the 18mm screws holding the case onto the device.
Remove the bottom case. Be careful of the connector holding the case and the device together.
1024
Step 2
- Locate the cable connected to the front lights.
- Pull apart the wires until the black clip separates.
Locate the cable connected to the front lights.
Pull apart the wires until the black clip separates.
Step 3
Front Bumper LED
- Grab the wire of the connector you disconnected from the case earlier and slide the entire light out away from the case.
Grab the wire of the connector you disconnected from the case earlier and slide the entire light out away from the case.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Keegan
Member since: 10/04/2018
632 Reputation
5 Guides authored
Badges:
8
+5 more badges
Team
Linn Benton Community College, Team S1-G1, Karnes Fall 2018
Member of Linn Benton Community College, Team S1-G1, Karnes Fall 2018
LBCC-KARNES-F18S1G1
3 Members
5 Guides authored
