Hover 1 Superstar Battery Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 minutes

Sections

Bottom Case
2 steps
Battery
3 steps

Flags

BackHover-1 Superstar
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Bottom Case

Flip your Hover-1 Superstar device upside down.
Using a Phillips #1 screwdriver, remove all twenty of the 18mm screws holding the case onto the device.
Remove the bottom case. Be careful of the connector holding the case and the device together.

Flip your Hover-1 Superstar device upside down.

Using a Phillips #1 screwdriver, remove all twenty of the 18mm screws holding the case onto the device.

Remove the bottom case. Be careful of the connector holding the case and the device together.

1024

Step 2

Locate the cable connected to the front lights.
Pull apart the wires until the black clip separates.

Locate the cable connected to the front lights.

Pull apart the wires until the black clip separates.

Step 3

              Battery

Locate the four 14mm screws securing the battery bracket.
Remove the screws with a Phillips #1 screwdriver.

Locate the four 14mm screws securing the battery bracket.

Remove the screws with a Phillips #1 screwdriver.

Step 4

Pull and disconnect the cable connector that is connected to the battery.

Pull and disconnect the cable connector that is connected to the battery.

Step 5

Pull on the battery until it separates from the hover board. You may need to use some force.
Be sure the battery is disconnected before performing this step to avoid electrocution.
There will be a loud crack when the battery is removed. This is normal due to the adhesive on the back of the battery.
Pull the battery out of the hoverboard. Move wires away from the battery if necessary.

Pull on the battery until it separates from the hover board. You may need to use some force.

Be sure the battery is disconnected before performing this step to avoid electrocution.

There will be a loud crack when the battery is removed. This is normal due to the adhesive on the back of the battery.

Pull the battery out of the hoverboard. Move wires away from the battery if necessary.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors

                    Keegan

Member since: 10/04/2018

632 Reputation

                                      5 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Linn Benton Community College, Team S1-G1, Karnes Fall 2018                        

                                                  Member of Linn Benton Community College, Team S1-G1, Karnes Fall 2018 



                    LBCC-KARNES-F18S1G1                     


                                            3 Members                     


                                            5 Guides authored

chivitbprince Boonking - Jun 4, 2020

How do u get a 25.2v battery at for my hover-1

Introduction#

What you need#

Team#

Introduction

What you need

Team