Difficulty
Difficult
Steps
3
Time Required
15 minutes
Sections
1
- Headlight
- 3 steps
Flags
0
BackHover-1 Rally
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Step 3 requires you to remove two wires from the headlight. This will require you to desolder the wires in order to detach them.
Make sure to power off the scooter before beginning this guide.
What you need
Step 1
Headlight
- Remove four 5 mm screws with a 5 mm hex key.
- When reinstalling, gently tighten each screw simultaneously to apply equal pressure on both sides of the casing.
Remove four 5 mm screws with a 5 mm hex key.
When reinstalling, gently tighten each screw simultaneously to apply equal pressure on both sides of the casing.
1024
Step 2
- Apply pressure to both ends of the headlight to remove it from the scooter.
- Be gentle. You will feel some resistance due to the glue that is used.
Apply pressure to both ends of the headlight to remove it from the scooter.
Be gentle. You will feel some resistance due to the glue that is used.
Step 3
- Once the headlight is loose from the scooter, disconnect the two wires using a soldering iron.
- Use this soldering guide for tips on using a soldering iron.
Once the headlight is loose from the scooter, disconnect the two wires using a soldering iron.
Use this soldering guide for tips on using a soldering iron.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
Cami Lowrey
Member since: 02/07/2020
435 Reputation
3 Guides authored
Badges:
8
+5 more badges
Team
Cal Poly, Team S7-G2, Regan Winter 2020
Member of Cal Poly, Team S7-G2, Regan Winter 2020
CPSU-REGAN-W20S7G2
6 Members
6 Guides authored